Advertisement
951-691
The indestructible stand for bin
liners
Item-no.: 221-211, 211-212
Are you fed up with this happening?
We've got the solution for you, the Liner Bin
Assembly instructions
Unpack the nuts and bolts and also get two pens (or pencils, screws, screwdrivers
or similar objects) ready. Only start assembling the Liner Bin when the plastic
sheet has reached room temperature because it will be easier to bend when it is
warm. First, roll up the sheet as tightly as possible. So that it remains a little bent
when you release it again.
Now bend the sheet into a tube and align the holes with each other. Insert the
ballpoint pens (or similar objects) through two holes so that the tube remains in
this pre-bent shape.
Start with one hole at the edge. Take the oval-head screw and – if you are using
the product for Application 1 (liner outside, tube inside) – insert it from the outside
in through the hole. Screw on the nut from the inside and tighten. Insert the screws
from the inside out through the hole if you are using the product for Application 2
(liner inside, tube outside). Screw on the nut from the outside and tighten.
Advertisement
Table of Contents
Summary of Contents for Pro-Idee 221-211
- Page 1 951-691 The indestructible stand for bin liners Item-no.: 221-211, 211-212 Are you fed up with this happening? We’ve got the solution for you, the Liner Bin Assembly instructions Unpack the nuts and bolts and also get two pens (or pencils, screws, screwdrivers or similar objects) ready.
- Page 2 Finally, pull the rubber cord through. Tie a knot at one end. Now start at the fi rst hole next to the screw strip and thread the elastic band from the inside to the outside. Now, alternating from the inside towards the outside and from the outside towards the inside, thread the rubber cord through all the way around.
Need help?
Do you have a question about the 221-211 and is the answer not in the manual?
Questions and answers