Advertisement
Note: If the power source does not support
a selected voltage, the 529M will remain at
the nearest supported voltage below that
selected. For example, if 15V is selected and
15V is not supported by the source, then the
Output of the 529M will remain at 12V or 9V.
Remember to check the specifi cations of
your power source to determine the available
voltages.
WARNING! Do not increase the
voltage above that recommended for
the devices(s) you are connecting.
Exceeding the recommended voltage
may damage your device. Do not
forget you have set it to a higher
voltage and then connect it to a lower
voltage device as damage may occur.
If you regularly change voltages, it
is recommended to always visually
check the position of the switch
before connecting a device.
USB PD 3.0 Type C
Output
6V, 9V, 12V, 15V, 18V @ 3000mA Max
2.1mm center pin negative
Dimensions
2.4" x 1" x 1"
1.1oz
Construction
Aluminum case Blue anodized
STOP!
Please read this before
connecting your Mission 529M
USB-PD converter
Quick Start Guide V1.0
MISSION
ENGINE
www.missionengineering.com
info@missionengineering.com +1-866-333-1828
ING
Advertisement
Table of Contents
Related Manuals for Mission 529M
Summary of Contents for Mission 529M
- Page 1 For example, if 15V is selected and 15V is not supported by the source, then the output of the 529M will remain at 12V or 9V. Remember to check the specifi cations of your power source to determine the available...
- Page 2 To select a different voltage, fi rst remove the The 529M should be connected to a USB USB C cable from the input of the 529M. power source such as battery pack or wall Select the required voltage by using a small charger with a USB-C cable.
Need help?
Do you have a question about the 529M and is the answer not in the manual?
Questions and answers