Do you have a question about the STABILINE and is the answer not in the manual?
Questions and answers
Summary of Contents for Superior Electric STABILINE
Page 1
Model SBK350 Line Interactive UPS Installation, Operation and Maintenance Manual Thank you for purchasing the SBK350 Series STABILINE® Uninterruptible Power Supply..another Superior product! Expect exceptional performance. The unit is built to the highest standards for your complete satisfaction. To assure many years of uninterrupted service, please read and save this Manual.
Page 2
Important Safety Instructions - Save These Instructions • WARNING (SAVE THESE INSTRUCTIONS): This manual contains important instructions that should be followed during installation and maintenance of the UPS and batteries. • WARNING (CONTROLLED ENVIRONMENT): These units are intended for installation in a temperature controlled, indoor area, conductive free environment. • CAUTION: Risk of electric shock, do not remove cover. Refer servicing to qualified service personnel. • CAUTION: Do not dispose of batteries in a fire, they may explode. •...
Page 3
Introduction - Save These Instructions Intelligent Microprocessor Control The SBK350 STABILINE Uninterruptible Power Supply is an advanced line- interactive UPS based on microprocessor control. This means that it operates with the newest technology, high performance and powerful function. The SBK350 provides pure, reliable AC power to the critical loads - protecting them from utility power blackout, swells, sags, surges and interference.
Page 4
1.1 Front View ON/OFF/TEST/SILENCE Power Switch Press the ON/OFF/TEST/SILENCE power switch until the beep stops to turn ON or to turn OFF the UPS. When the UPS is working under normal (utility present) LINE MODE, the UPS’s self-test function can be activated by pressing the ON/OFF power switch for less than second.
Page 5
2. Installation Inspect the UPS upon receipt. Remove the rubber protective piece covering the ON/ OFF/TEST/SILENCE power switch on the front panel. The packaging is recyclable, keep it for reuse or dispose of properly. 2.1 Placement: Install the UPS in a protected area with adequate ventilation and free of excessive dust.
Page 6
3.2 Turn UPS on with Green Mode Disabled Press and hold the ON/OFF power switch until the alarm beeps twice (approximately 3 seconds). The UPS is now energized and the Green Mode Function is disabled. CAUTION: If the load is lighter than 15W, it is recommended that the Green Mode Function be disabled to avoid any inconvenience from automatic UPS shut-down.
Page 7
5. Maintenance and Storage 5.1 Maintenance 5.1.1. Keep the unit clean and vacuum the ventilation intake periodically. ... Wipe with soft damp cloth. 5.1.3. Check for loose and bad connections monthly. 5.1.4. Never leave the unit on an uneven surface. ... Position the unit to allow at least 4 inches clearance between the rear panel and the wall. Keep the ventilation intake open. 5.1.6. Avoid direct sunlight, rain and high humidity.
Need help?
Do you have a question about the STABILINE and is the answer not in the manual?
Questions and answers