Advertisement
Quick Links
π
H-6224
ON-SITE MOBILE
EYEWASH
• Read instructions to ensure proper installation,
then file with owner or maintenance department.
Compliance and conformity to drain requirements
and other local codes and ordinances is the
responsibility of the installer.
• Separate parts from packaging and make sure all
parts are present before discarding any packaging.
If any parts are missing, do not begin installation
until you obtain the missing parts.
• Test the unit for leaks and adequate water flow. The
inspection and testing results of this equipment
should be recorded weekly to verify proper
operation. This equipment should be inspected
annually to ensure compliance with ANSI Z358.1.
PAGE 1 OF 4
1-800-295-5510
uline.com
Tank
Cap
Pedestal
Tray
SAFETY INFORMATION
Snorkel
Clamp
Latch
Pierce
Drain Hole
• Workers who come in contact with potentially
hazardous materials should be trained regarding
placement and proper operation of emergency
equipment per ANSI Z358.1.
• This unit is to be used with tepid, potable water, as
defined by ANSI Z358.1.
NOTE: Avoid prolonged exposure to ambient
heat sources above 100°F and below 60°F.
1216 IH-6224
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for U-Line H-6224
Summary of Contents for U-Line H-6224
- Page 1 π H-6224 1-800-295-5510 uline.com ON-SITE MOBILE EYEWASH Tank Snorkel Clamp Latch Pedestal Pierce Tray Drain Hole SAFETY INFORMATION • Read instructions to ensure proper installation, • Workers who come in contact with potentially then file with owner or maintenance department.
- Page 2 LOCATION AND INSTALLATION MOUNT EYEWASH PEDESTAL TO WALL (OPTIONAL) Figure 1 CAUTION! Eyewash station weighs 60 lbs. when filled to capacity. Two-person installation is recommended to safely install unit. Mounting bracket screws and wall anchors (not included) must be strong enough to support the filled unit. Secure the mounting bracket to the wall with screws and wall anchors (not included).
- Page 3 OPERATION TEST EYEWASH UNIT Figure 3 1. After completing installation, test the eyewash station for proper operation by pulling down the tray. Check for proper water flow and quickly close the tray. Visually inspect the eyewash unit weekly for cleanliness and proper solution level (per ANSI Standard Z358.1-2014).
- Page 4 MAINTENANCE CLEAN EYEWASH UNIT NOTE: Follow the preservative manufacturer’s instructions for the proper use of water When using potable water and water preservative preservative. (recommended): INSPECT EYEWASH UNIT 1. Carefully remove the eyewash tank from the pedestal and drain the water solution from the tank Visually inspect the eyewash unit weekly for (dispose of the solution properly).
Need help?
Do you have a question about the H-6224 and is the answer not in the manual?
Questions and answers