Little Colorado Sodura MTLCPT Assembly Instructions

•
Made in America For assembly help or replacement parts, please email us at
WARNING: ADULT ASSEMBLY REQUIRED
WARNING: Assembly kit contains parts with sharp points.
WARNING: Package contains plastic bags that present suffocation risks for children.
WARNING: Assembly kit contains small parts that present choking hazards for children.

Assembly Instructions for Sodura Train Table

End Panel
4-1/2 " Flat Head Wood Screws

Contents:

1- Table Top
2- Table Sides
2- Table Ends
2- Brackets
8- Barrel Nuts
1- Allen Wrench
8- Joint Connector Bolts
You will need a standard Phillips head screwdriver to complete this assembly. An assistant will be very helpful.
1. Insert two of the Barrel Nuts into the two holes on one end of one Side Panel making sure that the
slotted end of the Barrel Nut is facing out. To align the Barrel Nut you should be able to look into the
smaller holes in the ends of the part and see the threaded openings. The Barrel Nuts can be rotated
with a screwdriver to make sure they are lined up correctly.
2. Position the Side Panel into the vertical slot in the End Panel so that horizontal slots on both parts
are aligned and screw in two of the joint connector bolts. Tighten each bolt using the Allen Wrench and
WARNING: Assembly kit contains parts with sharp edges.
Side Panel
Table Top
customerservice@littlecolorado.com
Joint Connector Bolt
to Barrel Nut Assembly