Connected flash alarm clock RLC20 Sound Connecting transmitters Dawn simulator Alarm clock1 Vibrating pillow pad 1 Alarm clock 2 Vibrating pillow pad 2 Flash system Battery level indicator...
Page 6
Connected flash alarm clock RLC20 Choice of Melody Hour setting Volume Minute setting Wake up time1 Wake up hour 2 Wake up minute1 Wake up minute 2 Flash and / or vibrating pilow Flash and / or vibrating pillow On (I) / Off (o) Alarm clock 1...
Page 7
Connected flash alarm clock RLC20 Speaker (melody) USB port Vibrating pillow pad connection person 1 ON / OFF connection button Power connection Alarm clock ON / OFF Time setting in 12h (English style) or 24h Dawn simulator ON / OFF...
Typical installation example : Intercom bell Person call Door opening Portal bell Baby cry monitor SMS & cell phone Gas detector Smoke detector detector button calls Waterproof door Long distance person Flood detector Vibrating and Fax ring sender Movement detector Illuminated &...
Technical characteristics Height: 12.5cm Width: 18.5cm Depth: 6.6 cm (bottom) - 3 cm (top) Weight: 474g Decoding Format: MCU Radio frequency: 433 Mhz Wireless device: Yes Power Supply: 5V USB Adapter Quantity of connected products: 20 units max 2 years warranty Thanks to the connected flash alarm clock, you will be aware of everything that is happening in your home in a precise way! This is a tailor-made tool that allows you to differentiate two...
Page 10
To check that your product is working properly: After plugging in your device, place it on a flat surface. To verify that your product is correctly connected: All you have to do is activate the previously connected transmitter, the white and colored (specific) flashes of the alarm clock will be activated and the corresponding pictogram will be displayed on the screen.
Page 11
Settings To connect your product: If you want to complete your package with other Jenile transmitters or if you have reset your connected flash alarm clock, you must then make the settings to connect your products to each other. To connect all products carefully follow the instructions. Each transmitter is activated in different ways, please refer to the user manual of your transmitter if necessary.
Page 12
To reset your product: Take a toothpick, a paper clip or a pen and long press the connection button corresponding to what you want to disconnect. Keep pressed until the pictogram flashes. Repeat the same operation on all the pictograms you want to reset.
Time setting To adjust the time, simultaneously press the two buttons (hour) and (Minute) at the top right of the alarm clock, the digits will flash, all you have to do is press the button set the hours and the button to set the minutes.
Page 14
Choice of alarm type You have the choice between 3 types of alarm: 1-flash (dawn simulator) 2-vibration (vibrating pad optional) 3-sound (5 melodies to choose from) If you want, you can combine the different types of alarms. To make your choice, press the button , you will see the pictogram appear next to the alarm time.
Page 15
Options: Vibrating pillow pad: The vibrating pad can be ordered individually or in pairs for couples who want to be woken up at different times using vibrations, plug your vibrating pads into the location shown below :...