Pyronix DIGI-GSM Quick Start Manual

D I G I - G S M
GSM Digital Communicator
RINS1559-4
LARGE HOUSING:
8x Screws
M3 x 5
4x Pillars
M3 x 8
The DIGI-GSM is only available for the PCX 46 and Enforcer V9 and above.
The Printed Circuit Board
Antenna
Connection
12V DC
Connection
Modem
Data
Connection
Inserting a SIM Card
SIM CARD NOT PROVIDED
The GSM Modem is compatible with GSM networks
and will not work with networks that provide a 3G
Signal only (for example the 3 network).
T: +44(0)845 6434 999 (local rate) Or T: +44(0)1709 535225 (For Alarm Engineer only)
Customer Support opening hours: 8:00am – 6.30pm Monday to Friday
SMALL HOUSING:
4 x Screws
4x
1/4
x4
SIM
CARD
slot
Status
LEDs
LED Status
ORANGE
ORANGE GREEN
SIGNAL STRENGTH
ON = Signal Strength Full
SIGNAL STRENGTH
OFF = No Signal Strength
Troubleshooting:
- If no signal strength is displayed, try relocating the
antenna in a new location.
- If the GSM is not dialling out, check the modem is
enabled in programming, the SIM card is inserted and
the modem data connection is connected correctly. Also
check to see if the GREEN LED is pulsing which will
show that it is connecting to the network.
- If no LEDs are displayed, check the power connection
or connect a separate +12V to the GSM
- If the GSM is not recognised with the control panel,
power down and back up.
ENFORCER HOUSING:
Clips into place
GREEN PULSING
Connecting to network
SIGNAL STRENGTH
ON = Signal Strength 50%
ORANGE ON
When making a call