Pehratek Products ELITE XM-5000 VRA IR Instruction Manual

REMOTE CONTROL
(REM-5000 IR)
STEP ONE:
Posi6on each reinforcer box over or near the le: and right
sound field speakers.
Moun6ng these boxes to the wall of the sound room can be done by one
of these four op6ons:
1) Using op6onal Dual Arm moun6ng brackets (DUA-001)
2) Using self tapping screws through predrilled holes on back of box
3) Using Velcro or double back tape to mount to top of loudspeakers.
4) Use op6onal corner moun6ng brackets (INS-KIT2) for moun6ng box-
es in the corners of the sound booths.
STEP TWO:
Insert cables for power and IR sensors into bo-om of each
VRA box connector block. (See LEGEND) The high power IR LEDs will
flood a room with infra-red light reflec6ons to ac6vate the boxes even if
they are not directly pointed at the reinforcer box.
STEP THREE:
Placement of IR sensors IS CRITICAL for op6mal pickup.
Posi6on IR sensor higher up on wall or window where the remote con-
trol is typically pointed when used TYPICALLY THE IR SENSORS ARE
ROUTED THROUGH THE JACK PANEL TO THE TEST BOOTH AND POSI-
TIONED NEAR THE AUDIOMETER. NOTE: Each box has built in IR sensor
to ac6vate units in the sound booth with the remote control.
STEP FOUR:
Mount centering box in between units onto wall using self
tapping screws through the eyelet holes in back of box or double back
tape to hold into posi6on. Insert RCA cable into bo-om jack on either
XM-5000 unit to operate with remote control.
*Volume can only be adjusted when unit is not ac vated.
INSTRUCTION MANUAL
XM-5000 VRA
ALL-ON FEATURE
IR
2-Rectangular Plexiglass Boxes
1–Wireless Remote Control
2– DC 9 Volt Power Adapter
2-12' Extension Cables (M-F)
1-Power Spli-er Y-Cord
2-6' Extension Power Cable
1-IR Spli-er Y-Cord
Y-CORDS
(CAB-88)
(CAB-66)
6' POWER EXTENSION CABLE (CAB-010)
24' IR EXTEN CABLE (CAB-11 M-F)
PUSH
POWER COAX
2.1mm
3.5mm
Plug
ELITE SERIES
REV 2022
PACKAGE CONTENTS
(REM-5000)
(ADA-13)
2– IR Sensor (
IR-SENS)
(CAB-011)
(CAB-66)
(CAB-010)
(CAB-88)
IR SENSOR
(IR-SENS)
DC 9 VOLT
(ADA-13)
Use moun6ng
holes on back of
box to screw to
wall or use
moun6ng brackets
LEGEND
Volume DOWN Bu-on*
Volume UP Bu-on*
Silver
POWER-Coax
IR SENSOR-BLUE
CENTER BOX –RED
WIRED OUTPUT-BLACK
WIRED INPUT-BLACK
(2.1)
(RCA)