AUSTRALIAN MONITOR ZONEMIX Quick Start Manual

QUICK START GUIDE
This quick start guide provides a brief overview of the key features of the ZONEMIX system.
A full manual can be downloaded from: www.australianmonitor.com.au/collections/zonemix-system
FRONT PANEL
1
2
SIGNAL PRESENCE LEDS
1
Green LED = Signal present
Flashing Green = Muted (Outputs only)
Red = Clipping (Reduce input level).
2 SD CARD CONNECTOR
Used to store messages, tones and paging
announcements. Accepts full size SD card,
maximum density 2TB, FAT32 file system
required.
OUTPUT ZONE KNOB
3
Rotate left and right to select the output zone.
Push and hold for 2 seconds to enter Audio
Setup mode.
MIX KNOB
4
Rotate left and right to select the input channel
mix desired for the output zone.
Push and hold for 2 seconds to enter System
Setup mode.
LCD CHARACTER DISPLAY
5
20 x 2 Blue LCD character display
3 4
www.australianmonitor.com.au
SCAN TO DOWNLOAD FULL MANUAL
5 6
PRESETS KNOB
6
Rotate left and right to cycle through the
available presets and push to select.
Push and hold for 2 seconds to save to a
preset.
VOLUME KNOB
7
Rotate left and right to adjust the volume level
of the currently selected input or output.
Push the knob to mute or unmute.
USB-C CONFIG PORT
8
Connect to a PC using a USB-C cable to
control the ZONEMIX via the PC Control
Software
STATUS LED
9
This blue LED will illuminate indicating that the
ZONEMIX is on and receiving mains power.
POWER SWITCH
10
Press the switch up to power on and down to
power off.
8 10
7 9