Advertisement
Quick Links
Thank you for purchasing Air Lift Products
Mailing Address:
AIR LIFT COMPANY
P.O. Box 80167
Lansing, MI 48908-0167
For Technical Assistance call 1-800-248-0892
"The Choice of the Professional Installer"
Street Address:
AIR LIFT COMPANY
2727 Snow Rd.
Lansing, MI 48917
Local Phone: (517) 322-2144
Fax: (517) 322-0240
EasyStreet Digital Controller
Kit No. 27600
www.airliftcompany.com
Please read these instructions completely
before proceeding with installation
Failure to read these instructions can result in mis-installation
Installing the Digital Controller
System Requirements ............................................ 1
ECU Diagram ....................................................... 1
Setting the Features .............................................. 1
Preparing the System ............................................ 3
Mounting the Display Panel ................................... 4
*Kit Installation Diagram ....................................... 5
Valve Wiring and Plumbing Schematic ................... 7
Assembling the Transducer .................................... 8
Attaching the ECU and Display Panel .................... 8
Operational Instructions ........................................ 9
MN-628
(04507)
ECR 5262
Advertisement
Summary of Contents for Easystreet 27600
-
Page 1: Table Of Contents
MN-628 (04507) EasyStreet Digital Controller ECR 5262 Kit No. 27600 www.airliftcompany.com Please read these instructions completely before proceeding with installation Failure to read these instructions can result in mis-installation Installing the Digital Controller System Requirements ..........1 ECU Diagram ............1 Setting the Features .......... -
Page 2: System Requirements
System Requirements Operational Instructions (Continued) Amperage Gross Vehicle Weight Rating - The maximum If Ride Ht is enabled, the system will set the airbag pressures to the saved setting values on start-up. If Auto is enabled, allowable weight of the fully loaded vehicle (including Do not exceed three amps of current per each one the system will then enter auto-mode. - Page 3 Operational Instructions Setting the Features (Continued) Three Basic Operation Modes: Using the Voltometer 1. Press and hold the Ride Height button (B) for greater than 3 seconds until “Edit Options” appears. Manual-Mode The system displays the actual airbag pressures, and the user controls the pressure manually. The system displays the pressure settings and automatically maintains the prescribed airbag 2.
-
Page 4: Preparing The System
Preparing the System Assembling the Transducers 1. Disconnect the red compressor power wire from 2. Disconnect the pressure switch from the tee on the 1. Apply thread sealant to the bushing and install into the pressure switch connected to the end of the the branch tee (Figure 8). -
Page 5: Mounting The Display Panel
Valve Wiring and Plumbing Schematic Mounting the Display Panel 1. Determine the mounting location of the display 3. Stick the display unit to the mounting bracket. panel. 4. Attach the mounting bracket to its mounting NOTE: The display panel can be mounted by location in the same manner. -
Page 6: Kit Installation Diagram
Kit Diagram Hardware List Item Part No. Description Quantity 25000 Digital Control ECU/Harness 27025 Digital Controller For Reference Only For Reference Only 24001 Pressure Transducer Not included in kit Not included in kit 26440 ECU/Display Cable 10415 Display Mounting Bracket For Reference Only For Reference Only 10519...