mammotome Elite MEH1 Quick Reference Manual

Charging the Holster
After cleaning and disinfecting, place the holster into the
charging base. The holster will emit a two-tone beep to indicate
correct placement into the base.
Holster Inside Charger
SOLID
= Battery is fully charged.
FLASH
= Battery is charging.
FLASH =
Battery is charging. Holster must remain on charging base.
Holster Outside Charger
SOLID
= Adequate charge available.
FLASH
= Sufficient charge to complete one procedure.
SOLID
= Insufficient charge. Return holster to charging base.
Troubleshooting
If the fault indicator light is illuminated:
• Ensure the probe is outside the patient.
• Disassemble and reassemble the probe and holster.
• If the problem persists, replace with a new probe.
If the battery indicator light is not illuminated:
• Press any biopsy button and re-check the indicator
lights.
• If the problem persists, remove probe and return
holster to charging base (ensuring proper seating).
Quick Reference Guide
When charging, set the holster on top
of this guide for quick, easy reference.