Page 1
ORDER NO.SD0102U31C1 Wet/Dry Rechargeable Shaver ES3040 / ES3041 / ES3042 SPECIFICATIONS SPECIFICATIONS Power source AC100-120V, 50-60Hz / (Automatic voltage conversion) Motor voltage 1.2V DC Power consumption Charging time 8-hours Weight 140g <SUPPLIED ACCESSORIES> Soft case 2001 Matsushita Electric Works, Ltd. / All rights reserved.
2. WIRING CONNECTION DIAGRAM 3. DISASSEMBLY METHOD Follow the procedure below to disassemble the main block. 1. Remove cap, foil frame and inner blade. 2. Unhook right and left side of hooks at upside using a flat screwdriver with a position 8mm sliding above. Then slightly move trimmer until position marking 2 , and unhook lower side of hooks.
Page 3
5. Take out the chassis block from housing by pushing a head of driving head down with switch OFF. 6. Loosen two screws and remove bottom cover. NOTE : When reassembling, replace the new waterproof rubber. 3.1. BATTERY REPLACEMENT To remove battery, fix the top of battery terminal with a flat plate and lifting up the battery pin.
4. CAUTION IN ASSEMBLY 1. Bottom Cove Make sure whether there is NO foreign substance sticking around a part covered with water weal. 2. Chassis Make sure of terminal plates whether there is No deformation or their condition. 3. Driving Head Insert a motor tip pin into the hole of driving head and install driving head in chassis.
5. Trimmer Set a position where marking 2 , and hook lower side of two hooks. / With a position 8mm sliding down, hook right and left side of hooks at upside. 5. TROUBLESHOOTING GUIDE < SYMPTOM > < CAUSE > <...
<CHECK SWITCH.> Repair contact replace Check contacts of switch. chassis. <CHECK MOTOR.> Replace motor. Okay if motor rotates when DC1.2V is applied to (+) and (-) terminals. <CHECK RECHARGEABLE BATTERIES.> Replace rechargeable battery. Okay if voltage of rechargeable battery is more than approximately 1.2V between (+) and (-) terminals.