Summary of Contents for CIC Torus 15
- Page 1 Installation Guide For assistance, please email the manufacturer at support@torus-technology.com Diagram above is shown with optional reader attached.
-
Page 2: Safety And Warnings
Neither CIC Technology nor any of its directors, employees or other representatives shall be responsible for any loss that you may incur, either directly or indirectly, arising from any use or decisions based on the information provided. -
Page 3: Before You Begin
Before You Begin Power The cabinet can be powered from a regaular power outlet or by using POE. Make sure the chosen option is ready and available before commencing installation. AC Power Power over Ethernet The relevant ports should be within 110-240V POE / POE+ / POE++ 2m / 6’... -
Page 4: Package Contents
• attaches to the wall at 6 points instead of 4 • includes an additional strap to support the weight of the keypanel • has 2 ribbon cables that connect to the Control Unit. Torus 15 Torus 25 Torus 50... -
Page 5: Installing The Cabinet
Installing the Cabinet Attach the mounting bracket to the wall The mounting bracket is connected, but not secured, to the back of the cabinet. Height: 1600mm / 63” Gently and carefully tilt the cabinet forwards so from the floor. you can remove the bracket. Find the desired location on the wall and mark the holes ensuring the bracket is level. - Page 6 Hang the Cabinet on the Bracket Lift the cabinet onto the mounting bracket There are two pins at the top of the bracket that will locate into keyhole slots in the back of the cabinet. Once both pins are inserted, the cabinet will hang in place, supported by the bracket The cabinets are very heavy - safe handling methods must be obvserved.
-
Page 7: Check Connections
Lower the Keypanel Find the latch in the top of the right side of the cabinet. Gently push it away from you to release the key panel. Make sure the main door is open and lower the key panel. Screw the Cabinet to the Bracket 10mm Open Ended Ring Wrench/Spanner Ratchet Driver with 10mm socket Secure the cabinet to the bracket using the screws... -
Page 8: Check All Connections
Bring in the Cables Now that the cabinet is secured to the wall, you can bring the network cable (and power if not using POE) into the cabinet. Check all Connections Follow this diagram and make sure all of the cabling is plugged in securely to the back of the control unit. - Page 9 Startup the Cabinet Close both doors. Tap the screen to boot up the cabinet. Enter Provisioning Key End-points Provisioning Key Ports IP Address The cabinet will show you if the Enter the provisioning key. necessary network configurations have been made. If not, you will be A secure connection will be made unable to progress to the next step.
- Page 10 Installing a Reader User ID If the cabinet is already in a powered-on state, make sure you gracefully shut it down first. Settings 1. Login as a cabinet admin, 2. Tap settings, 3. Tap shutdown. Login Shutdown Wait for the screen to turn completely black. Open Right Hand Door The reader will be Use the override key...
-
Page 11: Drill Holes
Rear of Control Unit Panel Wire the Reader The cabinet is capable of accepting inputs from Wiegand or OSDP devices. Every reader is different, so follow the manufacturer’s instructions and connect it to the appropriate point on the control unit. OSDP (RS485) Drill Holes Keep the control unit face down on a...
Need help?
Do you have a question about the Torus 15 and is the answer not in the manual?
Questions and answers