Subscribe to Our Youtube Channel
Summary of Contents for SI Zen 2 Pocket
- Page 1 Zen 2 Pocket Installation Instructions Zipper Tracks and Cable Guides INSTALLERS: PLEASE LEAVE THIS MANUAL WITH THE OWNER. Doc. # 400163 | v. 1.2 | 15 June 2022...
- Page 2 Limited 1 year warranty on Screen Innovations products Screen Innovations warrants its products, to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser provided they are properly operated according to Screen Innovations' instructions and are not damaged due to improper handling or treatment after shipment from the factory.
-
Page 3: Table Of Contents
TABLE OF CONTENTS Operating and Care of Your Shade � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � 1 Before Proceeding �... -
Page 4: Operating And Care Of Your Shade
OPERATING AND CARE OF YOUR SHADE Operation of the shade systems should only be performed by responsible parties. Always check the path of the Zen 2 Shade before operating to ensure that the path is clear of furniture or obstacles that could prevent full operation. Monitor the Zen 2 Shade for smooth operation through its entire range. -
Page 5: Before Proceeding
BEFORE PROCEEDING Read the instructions in their entirety before proceeding. Actions contrary to the instructions invalidate the warranty and may result in serious damage and/or injury. Preparing for installation– It is crucial that all installations are planned out carefully before specifying a shade order. -
Page 6: Parts In The Box
PARTS IN THE BOX – ZEN 2 POCKET Shades Zipper Tracks Only Case Assembly Left and Right Zipper Track Assemblies Mounting Bracket Options Cable Guides Only (2) Cables Thread size (1/4 x 20) (2) L Brackets Idler Slider Motor Slider... -
Page 7: Installation - Mount The Brackets
INSTALLATION – MOUNT THE BRACKETS BEFORE INSTALL– check upper corners of the pocket as necessary to ensure no interference issues with brackets. Use appropriate fasteners to mount to the ceiling or wall 1.5” less than the ordered shade width. NOTE: Ensure the fasteners used are adequate for the weight of the Zen 2 Shade and the structure. Jam Mount Ceiling Mount... -
Page 8: Installation - Mount The Cassette
INSTALLATION – MOUNT THE CASSETTE Installation requires two or more people and/or hoisting equipment. Please use safe lifting and rigging techniques. Avoiding sharp tools, remove the roll from its packaging on a soft, clean surface. Discard any foam or excess packaging. Place the bracket insert into the idler side first;... -
Page 9: Installation - Material Roll
INSTALLATION – THE MATERIAL ROLL After pocket brackets are mounted, slide in the material roll along with the mounting plates on each end. Slide the plate into the brackets; the plate will “click” into place. - Page 10 INSTALLATION – THE MATERIAL ROLL Use the thumb screws to secure both ends. Fasten the thumb screws on the mounting plates to secure the material roll.
-
Page 11: Installation - Zipper Tracks
INSTALLATION – ZIPPER TRACKS Note: For cable guide, see page 13. Disassemble the track by removing the screws holding the zipper track assembly to the mounting side of the track. Pull the zipper track assembly away from the mounting side. For the next step, use fixed track side “a”... - Page 12 INSTALLATION – ZIPPER TRACKS Position the fixed track 1” below the brackets and in line with the fabric. Outside of the track should be flush with pocket jam. Note: Make sure that the tracks are mounted square to the bracket and plumb from all directions.
- Page 13 INSTALLATION – ZIPPER TRACKS Use appropriate fasteners to secure the tracks against the mounting surface. Note: Pre-drilling for anchors along the score line will expedite and simplify the installation process. Refer to side “a, ” side “b” on page 8.
- Page 14 INSTALLATION – ZIPPER TRACKS Angle the top of the zipper track housing and align under material path. Feed the zipper into the top of the zipper track housing and pivot the bottom until it seats with the fixed track.
- Page 15 INSTALLATION – ZIPPER TRACKS Secure the zipper track housing to the fixed track with the provided screws.
-
Page 16: Installation - Cable Guides
INSTALLATION – CABLE GUIDE MOUNTS a. Run the cable through the hem bar end cap and position the crimped end just above the cable mount. b. Capture the crimped end of the guide cable as shown in figure “b.”... - Page 17 TENSIONING – THE CABLE GUIDES Screw the tensioner to the mounting surface, cut the cable to the appropriate length (see note A below), and insert the cable to the tensioner. See note B, to tighten the cable. Set tension by rotating the locknut clockwise;...
-
Page 18: Line Voltage (110V Ac/ 60 Hz) Wiring
If you need to re-set the limits, or add/delete a transmitter or channel, or set a new pref- ferred position, then Scan the QR code, alternately use the link below, go to the guides tab to access https://si-website-files.s3.amazonaws.com/Downloads/Programming+Guides/quick- motor-commisioning-guide.pdf... -
Page 19: Line Voltage (Ac - 485 Control) Wiring
Terminate the data wires into the provided terminal block shown below for 485 control wiring. Motor Quick Commissioning Guide: Based on your order, refer the motor (485/ RTS) your screen/shade uses. Scan the QR code, alternately use the link to access: https://si-website-files.s3.amazonaws.com/Downloads/ Programming+Guides/quick-motor-commisioning-guide.pdf Pin 1... - Page 20 RESET AND PROGRAMMING Motor Reset and Pairing with Remote Control NOTE: Somfy RTS motors use the same procedure to Pair and Unpair an RTS transmitter; you must power only one motor at a time when configuring. 1. Start with having power applied to the motor. 2.
-
Page 21: Controls Guide Reference
RESET AND PROGRAMMING 7. Press and hold the MY/STOP button until the shade jogs once to complete and exit the Motor Programming. 8. Press and release (do not hold) the programming button on the back of the remote, the shade will jog one time confirming the programming completion. - Page 22 NOTES...
- Page 23 NOTES...
- Page 24 Screen Innovations 9715-B Burnet Rd, Suite 400 Austin, TX 78758 512.832.6939 www.screeninnovations.com Doc. # 400163 | v. 1.2 | 15 June 2022...
Need help?
Do you have a question about the Zen 2 Pocket and is the answer not in the manual?
Questions and answers