Safety Xpress BOLSM140 Product Information & Installation Manual

P
Tools Required:
• Hammer drill with correct sized drill bit
• Fixing kit
• The correct sized socket
• A hammer
• A hand broom or industrial vaccum
Installation:
1. Read all instruction steps from
beginning to end.
2. Determine exactly where the bollard
will be placed. If you are installing more
than one bollard, it is a good idea to
mark the ground to ensure that you
have a straight line to assist you with
the correct placement of your bollards.
3. Using your hammer drill, drill a guide
hole in the surface, through each hole
in the bollard using the drill bit. (This is
to mark the surface so that you know
where to continue to drill).
1300 049 246
PRODUCT INFORMATION &
Surface Mount Bollard
SKU
Material
Colour
Dimensions:
Re ective
FREE
Item Weight
Fixings
2 2
Fixings
MONTHS MONTHS
4. Remove the bollard and brush or vacuum
5. Continue to drill each guide hole to almost
6. If you are using a plastic plug component,
7. Place the bollard over the holes, line up
8. Use your socket to tighten the screw if
INSTALLATION GUIDE
Specifications
BOLSM140
Hot Dip Galvanised Steel
Powder Coated Yellow with
Class 1 Red Reflective Tape
Height: 1300mm
Diameter:
140mm (Pole) 300mm (Base)
Wall Thickness: 3mm
Base: 4 Mounting Holes
16mm each in Diameter
18.6kg
4 x FREE Mounting Bolts Includ-
ed per bollard
(standard fixings kit)
away the dust.
the entire length of your fixings.
put it in the drilled hole and hammer in.
and place your fixing in the holes and
screw or ahmmer in.
applicable. Be careful not to overtighten.
www.safetyxpress.com.au