Solaborate HELLO2 Quick Start Manual page 5

ISED Regulatory Compliance
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic
Development Canada's licence-exempt RSS(s). Operation is subject to the following
two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause
undesired operation of the
device.
This equipment complies with IC RSS-102 radiation exposure limits set forth for an
uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between
the radiator and your body.
The device for operation in the band 5150–5250 MHz is only for indoor use to reduce
the potential for harmful
interference to co-channel mobile satellite systems.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d'Innovation,
Sciences et Développement économique Canada applicables aux appareils radio
exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes :
(1) L'appareil ne doit pas produire de brouillage;
(2) L'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en
12
SETTING UP HELLO 2
1. Connect the device to either Ethernet or Wifi using the HELLO Remote 3 after device
has successfully booted and shown on the TV screen.
2. Once the device is connected to the Internet the device will start downloading the
latest update or your specific company software configured through the online
administration console.
3. In case there are network restrictions the IT Admin should whitelist these domains
in order for the device to receive the update:
login.solaborate.com
api.solaborate.com
signalin.solaborate.com
mobile.solaborate.com
ota.solaborate.com
4. The device will install the downloaded update and the device will be ready for use.
05