Download Print this page

Intelligent Home VT-593 User Manual

Table of Contents

Download this manual

VT-593 Outdoor Camera User Manual

Precautions: Do not install camera/bell where there would be a bright light behind the visitor (or where there

would be a bright background), or in a place where the camera lens would be directly exposed to sunlight or a

bright light. If light shines directly into the outdoor camera lens, the image will be over-exposed; it will look white or

silhouetted. Take precautions against this. Do not install the unit in places where is constant vibration, extreme heat

or unusual external interference.

1. Parts and functions

Microphone

Camera Lens

Night View LED

Speaker

Nameplate

Call Button

- 1 -

33 mm

124 mm

Press down on the right side of the name plate

cover, then hold down and shift to the right to take

off the cover. Place the name paper between the

cover and the plastic base.

Table of Contents

Do you have a question about the VT-593 and is the answer not in the manual?

Page 1 VT-593 Outdoor Camera User Manual Precautions: Do not install camera/bell where there would be a bright light behind the visitor (or where there would be a bright background), or in a place where the camera lens would be directly exposed to sunlight or a bright light.
Page 2 3. Terminal Description 3 2 1 1R 2W 3Y 4B 3 2 1 1R 2W 3Y 4B ● 1R Power positive. +12V present when Outdoor Station calling or being monitored. ● 2W Power negative (GND) ● 3Y Image signal (Video signal) ●...
Page 3 5. Install Condition The recommended installation height of both Door Station and Monitor is from 160~165 cm. The Camera can not be installed in a place that hard/large light sources can cover the lens of the camera(for exmaple, the street light or Sun light), other wise the video image will have lower contrast. 6.
Page 4 8. Connect an electron lock(power-ON-to-open) 1. When connecting an electric lock, an external power supply is needed (not included). Safety Type: Power-on-to-open The lock consumption must not 2. The rating of the lock must be less than DC 48V greater than 48V 1.5A. 1.5A.