Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for MaxAssure UV-MAX
- Page 1 UV-C Mobile Surface Disinfection Unit USER MANUAL Models: UV-MAX UV-MAX LO-PRO...
- Page 2 MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE CREATED BY THE DESCRIPTIONS AND DEPICTIONS OF THE PRODUCTS SHOWN IN THIS MANUAL. MaxAssure makes no warranty (and assumes no liability) as to function of equipment or operation of systems built according to customer design or of the ability of any of its products to interface, operate or function with any portions of customer systems not provided by MaxAssure.
- Page 3 INDEX Advisories (Purpose/Contents) Page 4 Safe Operation Procedure Page 5 Safety Guidelines Page 5 System Description Page 6 System Delivery Page 7 Operation Overview Page 7 Operation Settings (Default) Page 8 Operation Settings (Customizable) Page 8 Cycle Stop Status Screens Page 9 System Care Page 10...
- Page 4 ADVISORIES Purpose Contents The MaxAssure UV-MAX system has been designed to offer This manual will serve as your reference guide for direct disinfection exposure to surface areas. The system installation, operation, and service of your UV-MAX device. design allows for microbial disinfection control.
-
Page 5: Safe Operation
You should never look directly at a UV lamp in operation without wearing approved safety glasses. Safety glasses should be made of any material other than Quartz or Teflon. The space should be vacant and closed prior to UV-MAX operation Never command the system on when the treatment space is occupied... -
Page 6: System Description
SYSTEM DESCRIPTION The MaxAssure UV-MAX is designed for maximum disinfection through the shortest exposure time. More UV-C wattage allows shorter exposure times to surfaces. Exposure times vary based on furthest distance from the UV- C source. The system design provides the optimum in: UV dosage output to footprint served •... - Page 7 SYSTEM DELIVERY / OPERATION OVERVIEW When you receive your UV-MAX you will need to unpack and inspect the system. Please perform the following procedure: Unpack your new system and stand upright Inspect fully for damage (If damage present, contact MaxAssure prior to use at 1-(239) 643-2778)
-
Page 8: Operation Settings
OPERATION SETTINGS Normal operation for factory default settings are covered on this page. Review system for condition. There should be no physical damage to the system Lamps should be clean System frame should be in good condition Display of system should be clean Plug in system power cord Ensure all personnel are out of treatment area Operate system... - Page 9 CYCLE STOP NOTIFICATIONS Cycle stop displays for normal system operation are covered on this page. Emergency Stop System Faults Should cycle deactivation occur by engagement of the Should cycle deactivation occur by means of a system fault, Emergency Stop button, the following method will be required the following method will be required to reset the system: to reset the system: 1.
- Page 10 DOSE GUIDELINES ULTRA & MAX MAX LP Competitor Model: Watts: Time: Time in Minutes Time in Minutes Time in Minutes Time in Time in Minutes Minutes Feet Room Room *Time in Time in *Time in Time in *Time in Time in Time in Time in From...
-
Page 11: System Care
SYSTEM CARE The MaxAssure UV-MAX system is designed for repeat performance with consistent results. Based on system designs, minimal maintenance is required. Adherence to the following regular service of your system should provide years of disinfection. Each Duty Cycle 1. Inspect the system interior, exterior, and lamps for clean conditions 2. -
Page 12: Troubleshooting And Faq
A: Verify the start cycle button is pressed A: Inspect the lamp for age or physical failure A: Contact MaxAssure Support for further information A: Verify the Emergency Stop is not engaged Q: My system is running fine, how do I verify the lamp output is correct? - Page 13 TROUBLESHOOTING & FAQ The below statements are listed as troubleshooting guidelines. Further information is available through MaxAssure support. Q: Is UV-C disinfection strictly line of sight? A: Yes, it needs to shine on the surface to disinfect. It will not go around objects or disinfect shadowed areas.
-
Page 14: Appendix A: Dose Guidelines
APPENDIX A: DOSE GUIDELINES ULTRA & MAX MAX LP Model: Watts: Time: Time in Minutes Time in Minutes Time in Minutes Feet Room Room *Time in Time in *Time in Time in *Time in Time in From Dims Square Minutes Minutes Minutes Minutes... - Page 15 MaxAssure, Inc. 1470 Don Street Naples, FL 34104 max-assure.com 1.239.643.2778...
Need help?
Do you have a question about the UV-MAX and is the answer not in the manual?
Questions and answers