Craftsman 944.364490 Owner's Manual page 8

TO STOP ENGINE
• To stop engine, release operator pres-
ence control bar. Wait until blade and
all moving parts have stopped and turn
fuel valve to OFF position if you do not
intend to re start the engine soon.
TO START ENGINE
NOTE: Due to protective coatings on the
engine, a small amount of smoke may be
present during the initial use of the product
and should be considered normal.
1. Be sure fuel valve is in the ON po si tion.
2. Move choke lever to ON (
3. Hold operator presence control bar
down to the han dle and pull starter
handle quickly. Do not allow starter
rope to snap back.
NOTE: The choke lever automatically
begins moving to the OFF position when
operator presence control bar is held
down to handle.
OFF
ON ( )
ON
Fuel valve lever
MOWING TIPS
• Under certain conditions, such as very
tall grass, it may be nec es sary to raise
the height of cut to reduce pushing effort
and to keep from overloading the engine
and leaving clumps of grass clippings.
It may also be necessary to re duce
ground speed and/or run the lawn
mower over the area a sec ond time.
• For extremely heavy cutting, re duce the
width of cut by over lap ping previously
cut path and mow slowly.
• For better grass bagging and most cut-
ting conditions, the engine speed should
be set in the FAST po si tion.
• Pores in cloth grass catchers can be-
• Keep top of engine around starter clear and
MULCHING MOWING TIPS
IMPORTANT: For best performance,
keep mower housing free of built-up
grass and trash. See "CLEANING" in the
Maintenance section of this manual.
) position.
• The special mulching blade will recut the
Choke lever
• Avoid cutting your lawn when it is wet. Wet
• For best results, adjust the lawn mower cut-
OFF
• Certain types of grass and grass con di tions
• Change your cutting pattern from week
8
come fi lled with dirt and dust with use
and catchers will collect less grass. To
prevent this, reg u lar ly hose catcher off
with water and let dry before using.
clean of grass clippings and chaff. This will
help engine air fl ow and extend engine life.
grass clip pings many times and reduce
them in size so that as they fall onto the
lawn they will disperse into the grass and
not be noticed. Also, the mulched grass will
bio de grade quick ly to provide nu tri ents for
the lawn. Always mulch with your highest
engine (blade) speed as this will provide
the best recutting action of the blades.
grass tends to form clumps and in ter feres
with the mulch ing action. The best time to
mow your lawn is the early afternoon. At this
time the grass has dried, yet the newly cut
area will not be exposed to direct sunlight.
ting height so that the lawn mower cuts off
only the top one-third of the grass blades.
If the lawn is over grown it will be nec es sary
to raise the height of cut to reduce pushing
effort and to keep from over load ing the
engine and leaving clumps of mulched
grass. For ex tremely heavy grass, reduce
your width of cut by overlapping previously
cut path and mow slowly.
may re quire that an area be mulched a sec-
ond time to com pletely hide the clip pings.
When doing a sec ond cut, mow across
(perpendicular) to the fi rst cut path.
to week. Mow north to south one week
then change to east to west the next
week. This will help prevent matting and
graining of the lawn.
MAX 1/3