Summary of Contents for DAN DRYER COLUMN
- Page 1 USER MANUAL COLUMN MODEL: 3192/3193/3194 (ADAPTER) MODEL: 3196/3197/3198 (BATTERY)
-
Page 2: Table Of Contents
TABLE OF CONTENTS DIMENSIONS AND TECHNICAL SPECIFICATIONS Dimensions and technical specifications Dimensions Unit of measurement: mm General safety information Installation DRYER DRYER DRYER DRYER Replacement of battery and pump Application Light indicator Cleaning and maintenance Replacement of disinfectant bottle Troubleshooting and corrective actions Parts list TECHNICAL SPECIFICATIONS DESCRIPTION... -
Page 3: General Safety Information
• The product should be checked on a regular basis. Never use a defective or malfunctioning unit • Never make alterations to the product affecting its performance. DAN DRYER’s product warranty does not cover product problems that result from misuse or alteration NOTE If the power cord is damaged, it must be replaced immediately. -
Page 4: Installation
9,1A) Connection with adapter. Push cable 9,2A) Push cable further upward and through through the cable lead-in at the bottom of the ’rack’. COLUMN. Power plug orientation pin 7) Connect the plugs on the wires 8) Insert drip tray in the support rails, lengthwise,... -
Page 5: Replacement Of Battery And Pump
INSTALLATION REPLACEMENT OF BATTERIES AND PUMP 10) Power connection to box. Connect plug to 11) Take off 5 litre bottle screw lid. We 14) Open the battery pack with a 15) Replace (4) D-batteries in the the control box. recommend you drill a Ø7 hole for the hose. screwdriver PH2. -
Page 6: Application
REPLACEMENT OF BATTERIES AND PUMP PRODUCT APPLICATION • Place hands approx 2-10 cm under the sensor to activate the 18) Remove existing pump unit. 19) Insert new pump. Make sure the pump dispenser. The dispenser will release 1-1.2 ml. disinfectant gel guideways fit those of the control box. -
Page 7: Cleaning And Maintenance
• Remove empty bottle from the rack sensor window Damaged sensor Contact DAN DRYER for advice • Replace with new bottle Tube disconnected from pump If the end of the tube is damaged, • Insert pump tube into the bottle please remove the damaged part. -
Page 8: Parts List
PARTS LIST No. Description Faucet complete End piece Parts inside faucet Rubber ring Holder for LED print and sensor Rubber gasket (top) Rubber gasket (bottom) Nylon bushing Clamping nut Tube/nozzle connecting part 10 Nozzle for disinfectant 11 Tube 700mm 12 Control box (DC) 13 Pump for disinfectant 14 AC/DC adapter 15 External battery box... - Page 9 DAN DRYER A/S Alsikevej 8 DK - 8920 Randers NV Tel: +45 8641 5711 Email: info@dandryer.dk dandryer.com...