TankScan InHand IR300 Setup Instructions

InHand IR300 Cellular Wi-Fi
Router Setup Instructions
Log in to Router
Connect an Ethernet cable into WAN/LAN1 Ethernet port on router. Connect
1
other end to a PC.
Plug in router's power cable.
2
Wait until Cellular indicator light begins to flash.
3
Open an internet browser and go to 192.168.2.1 to open login window
4
Enter adm for username.
5
Enter 123456 for password.
6
Set up Wi-Fi
Click on Network tab and select WLAN.
7
Click on Enable checkbox.
8
Following Wi-Fi settings are suggestions and can be modified as desired.
For SSID, enter desired Wi-Fi network name.
9
For Auth Mode, select WPA2-PSK.
10
For Encryption Method, select AES.
11
For WPA/WPA2 PSK, enter desired Wi-Fi password.
12
When finished, click Apply button.
13
Router will now execute and save setting changes. Once changes are saved,
14
router can be unplugged and moved to final location.
IMPORTANT: Changes made to Wi-Fi settings (such as changing SSID or password)
after setting up monitor(s) may result in monitor(s) losing connection to router.
Each monitor will then have to be configured again. It is recommended to finalize
any settings prior to installing monitor(s).
1 2
7
8
www.tankscan.com