Gainsborough K530 Quick Start Manual

Solar Stainless Steel Wall Light
K530
v001: 15/11/21
Please read and retain these instructions for future reference
For outdoor use
ASSEMBLY INSTRUCTIONS / INSTRUCTIONS FOR USE:
Unpack the components carefully. Please check all parts have been removed from the packaging.
BEFORE FIRST USE: Remove the protective film from the solar panel.
CHARGING AND OPERATION:
1. Twist transparent lamp shade at the bottom by turning it counter clockwise to access the "on/off"
switch. Push the switch to "on" position. Then replace the cover and position the light in a sunny
location. Charge the solar product by placing it under direct sunlight for at least 8 hours.
2. The light will work automatically. It will charge under direct sunlight during the day time and
illuminate at night.
NOTE: In order to test the lights simply cover the solar panel with your hand and the light should turn on
automatically.
Find an ideal Place for the Solar Light.
Place the solar light in an area where it will receive direct sunlight for at least 8 hours per day. The number of
hours the light will illuminate is directly proportional to the hours of sunlight it receives. If the light is placed
in a shaded area, it will not be able to fully charge and its illumination time will be limited. Do not place the
light near other outdoor lighting like porch or streetlights. These may fool the sensor and keep the light from
coming on, or cause it to turn off automatically.
Care and Maintenance Recommendations
1. Clean solar panel with a soft sponge every couple of weeks.
2. Make sure all connectors are still tight and no water getting in.
3. Make sure the switch is set to "ON" position.
ALWAYS POSITION IN DIRECT SUNLIGHT
Dimensions
(H) 13 x (W) 9.5 x (D) 12cm
Material: Stainless steel and plastic
•
SOLAR STAINLESS STEEL WALL LIGHT
•
3 X SMD WHITE LEDS (not replaceable)
•
BATTERY 1X "AA" 1.2V 600MAH, NI-MH, RECHARGEABLE
POLYCRYSTALLINE SOLAR PANEL
•
CHARGING TIME- 6-7 HOURS
Wall fixings included