Raita EV 200 KU Manual page 12

EV 200 KU
MANUAL
INSTALLATION
1) 1) Seat, connecting pipe and trolley (van)
A tank-shaped opening is sawn into the floor and back wall. If
necessary, use a level under the tank, a suitable seat height is 43-
50 cm. The trolley's space requirements are - 92 cm height and
80 with x 60 cm deep. The space requirement for the toilet space
is 50 (W) x 70 (W) cm, we recommend a larger toilet space, eg 100
(W) x 100 (W) cm.
The trolley is removed through an opening, hatch or door (for
emptying). If the toilet is used in winter, insulate the room and (if
necessary) install heating (purchased separately - min. +10
degrees C thermostatically controlled). Insulation (eg 50 mm)
base, walls, door or door. The liquid pipe is insulated.
Connecting pipe (diameter 20 cm - 50 cm, longer are also
available) is shortened depending on the installation site.
2. Ventilation
The ventilation pipe (D110) is led out. The end of the pipe must
be 60 cm above the ceiling. The delivery includes coupling part
D75 mm> 110 mm (+), and 110 pipe cap (-). Other necessities
are purchased separately (straight pipes and any 30-degree
angles). We recommend that the replacement air is taken into
the toilet from the outside. All air that leaves the room passes
through the ventilation. For winter use, we recommend
insulating the pipe in cold rooms.
3. Fluid pipe connection
Connect the liquid pipe (D32) to the tank or drain (0.7 m on
delivery, supply air branch and filter and 90 degree angle, extra
pipe if required). Excess liquid (installation method; ECO or
ECOSEP) is discharged into the drain with washing and rinsing
water (7). It can also be led to a separate biofilter and infiltrated
to the ground. It can also be collected (5) in a separate container
(20 l container included) or in a tank (6).
Separated urine (installation method SEP; delivery includes
separating seat outlet (D32 +), 1.5 m 32 hoses and bushing) is
collected in a separate container (20 l container is included in
delivery or tank (6)).
For winter use, we recommend insulation / heating of the liquid
pipe in the cold room.
To remove the trolley from under the seat:
1) Lift off the top of the seat
2) Raise the connection tube
3) Lift up the ventilation connection
4) Pull the trolley backwards
5) Remove the liquid pipe