BEA 71/16-421 Operator's Manual

Operator's Manual
Model No.:71/16-421
Stapler for 22Ga. Fine-Wire Staples
NOTE:
Please read and fully understand the
instructions in this manual before operating
the pneumatic tool. Carefully read through this
OPERATOR'S MANUAL to ensure efficient, safe
operation. Its is recommended that the manual
be kept readily available as an important
reference when using this tool.
Safety Information
WARNING:
BEFORE USING THE TOOL, READ CAREFULLY AND UNDERSTAND
THE FOLLOWING SAFETY INSTRUCTIONS.FAILURE TO FOLLOW
WARNING COULD RESULT IN DEATH OR SERIOUS INJURY.
1. WEAR SAFETY GLASSES OR GOGGLES.
Danger to the eyes always exists due to the possibility of dust being blown
up by the exhausted air or of a fastener flying up due to the improper
handling of the tool. For these reasons, safety glasses or goggles shall
always be worn when operationg the tool.The employer and/or user must
ensure that proper eye protection is worn.Eye protection quipment must
conform to the requirements of the American National Standards institute,
ANSI Z87.1 (Council Directive 89/686/EEC of 21 DEC.1989) and provide both
frontal and side protection.
The employer is responsible to enforce the use of eye protection equipment
by the tool operator and all other personnel in the work area.
NOTE: Non-side shielded spectacles and face shields alone do not provide
adequate protection.
2. DO NOT USE ANY POWER SOURCE EXCEPT AN AIR COMPRESSOR.
The tool is designed to operate on compressed air. Do not operate the tool on
any other high pressure gas, combustible gases (e.g.,oxygen, acetylene,etc)
since there is the danger of an explosion. For this reason, absolutely so not
use anything other than an air compressor to operate the tool.
3. OPERATE WITHIN THE PROPER AIR PRESSURE RANGE.
The tool is designed to operate within an air pressure range of 70 p.s.i. to
100 p.s.i.(5 to 7 bar.). The pressure should be adjusted to the type of the
work being fastened. The tool shall never be operated when the operating
pressure exceeds 120 p.s.i. (8 bar).Never connect the tool to air pressure
which potentially exceeds 200 p.s.i. (14 bar) as the tool can burst.