Parts List - Koolatron BITE SHIELD MK14 Owner's Manual

Look carefully between all packaging internal dividers for parts.
PARTS
(A) Main Unit
(B) Catch Lid
(C) Support Pole Assembly
(D) Base with Wheels
H
(E) Mosquito Catch
(F) Regulator with Hose
(G) Propane Tank (not included)
(H) Octenol Attractant
( I ) Locking Pin
(J) "C" size batteries required
(4 required, not included)
I
J
INSTRUCTIONS FOR OCTENOL MOSQUITO ATTRACTANT
1. Cut foil pack open using scissors. See Illustration A.
2. Remove Octenol cartridge from foil pack.
3. Connect "S" hook to Octenol cartridge. See Illustration B.
4. Connect other side of "S" hook to trap. See Illustration C.
Put larger end of "S" Hook through hole of the Octenol Cartridge
5. Wash hands thoroughly.
Please see package for cautions and instructions.
To order more Octenol cartridges please visit a retailer near you or visit us at:
www.kool tron.com

PARTS LIST

A
G
A
B
C
4
B
Upper pole
Press these pins and slide this pole into the
top pole, ensuring that the pins pop up
through the holes.
E
F
Bottom pole
C Press down firmly.
Slots face forwards
D
and back as shown.
Press in pins.
(+) (–)
(+)
(–)
(–)
(+)
(+)
(–)
ASSEMBLY
Step 1: Support Pole assembly.
Assemble the bottom pole and the upper
pole to form the Support Pole. Press the
pins on the side of the bottom pole and
insert them into the holes in the upper pole.
Make sure that BOTH pins pop up through
the holes in the upper pole.
Step 2: Support Pole connection to the Base.
Place the base on a flat surface. Insert the Support
Pole with the slotted side down as shown. Press in
firmly.
Ensure the pole has been inserted all the way down
and turn base sideways. Insert the locking pin
through the hole at the bottom until it comes out on
the other side as shown. Then, insert the safety pin
through the pin's hole as shown.
Step 3: Support Pole connection to the Main Unit
Pin pops into rear hole.
Attach the Main Unit to the top of the
Press in pins. Support Pole as shown. Press the pins on
the sides of the Support Pole to insert it into
the hole in the Main Unit. Make sure that
one of the pins pops up through the hole
at the rear of the Main Unit.
Step 4: Battery Installation
Open the battery compartment by pressing the tab at
the right side of the battery cover. Let the battery cover
hang from the unit as shown and insert four new "C"
batteries making sure that the positive and negative ends
of the batteries are arranged as in the picture. Close the
battery pack by tilting the cover upwards and to the right
until it snaps in place.
5