E3 Airmon Quick Start Manual

FCC Notices
Federal Communications Commission Notice
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions :
(1)this device may not cause harmful interference, and
(2)this device must accept any interference received, including interference that may cause undesired operation.
The Federal Communication Commission Statement
Notice: Changes or modifications not expressly approved by the manufacturer could void the user's authority to
operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
EU compliance standards
E3 enterprise declares that this wireless device is in compliance with the essential requirements and other relevant
provisions of the R&TTE Directive.
Copy of the EU Declaration of Conformity is available from the following Web site :
http://airmon.info/euro/compliance/
name and content of poisonous and harmful materials or elements
poisonous and harmful materials or elements
part name
Pb Cd Hg Cr 6+ PBB PBDE
printed circuit
×
○ ○ ○ ○ ○
board
case ○ ○ ○ ○ ○ ○
metal ×
○ ○ ○ ○ ○
battery ×
○ ○ ○ ○ ○
accessory × ○ ○ ○ ○ ○
○: Indicate that the concentration of the poisonous and harmful materials in
all homogeneous materials is below the limit requirement of SJ/T
11363-2006 .
×: Indicate that at least one material of this part, the concentration of
poisonous and harmful is beyond the limit requirement of SJ/T 11363-2006.
Thank you for choosing airmon. Before use, please read this manual thoroughly and pay attention to all notices for
correct and efficient usage. Please keep this book in a safe place for ready reference.
airmon
Nomenclature