Ortech OD-MC628VRC Instruction Manual

LED High Bay Sensor
MODEL OD-MC628VRC
1. The sensor should be installed by a professional electrician. Please turn off the power before installing, wiring, changing the
setting of the DIP switch
2. The sensor which installed in the plastic and glass lampshade will reduce the sensitivity. For every 3mm increase in thickness, the
sensitivity will be reduced by 20%
3. The dimming performance could be different from different 1-10V drivers
4. The light sensitivity threshold is in a sunny environment, no shadow and ambient light diffuse reflection. Lux level detected by sensor
could be different in different environment, weather, climate, time-of-day and season
5. The parameters of the sensor may need to be reconfigured in different installation environments. Please refer to the following
instructions or contact the manufacturer
6. This sensor is for indoor use only. It will affect the waterproof effect for outdoor use. Wind, rain, and moving objects around will cause
false triggering
7. The distance between any inductive sensors should be greater than 3m
8. Do not place the sensor close to high-density objects such as metal, glass, concrete walls, etc, false triggering could happen. When the
sensor is installed in a metal lamp, metal reflective surface, or a narrow enclosed environment, the microwave will be reflected
repeatedly and cause false triggering. Please reduce the sensitivity or contact the manufacturer for technical support
9. Please ensure that there are no moving signals around the sensor, such as fan, DC motor, sewer pipe, air outlet, etc., the sensor may
generate false trigger
10. You are advised to test 5 samples before mass application of sensor in a new lighting project
11. Due to continuous improvement, the contents of this instruction could be changed without prior notice
CAUTION
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.
Electrical products can cause death or injury, or damage to property.
If in any doubt about the installation or use of this product, consult a competent electrician.
INSTALLATION GUIDE
Initialization
1/ On/off function /3step dimming function: After power on, the sensor automatically turns on light at 100% brightness. After
10sec, it turns off the light. During the initialization, the sensor is not able to detect movement.
2/ 2-step dimming function: After power on, the sensor automatically turns on light at 100% brightness. After 10sec, it dims the
light to a low light level (set by stand-by dim level). During the initialization, the sensor is not able to detect movement.
Factory Setting
Detection area: 100%, Hold time: 5s. Stand-by Period: 0s. Stand-by dim level: 10%, Daylight Sensor: Disable
info@ortechindustries.com
www.ortechindustries.com
WARNING
WARNING — THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.
1. LED High Bay Sensors are not suitable for using in wet locations
2. Please keep the LED High Bay Sensor away from any corrosive substance, and please use dry
cloth when you clean it
3. LED High Bay can only be installed by a qualified electrician
4. Before installation or maintenance, please disconnect the power to prevent electric shock
Application Notice
13376 Comber Way
Surrey BC V3W 5V9
375 Admiral Blvd
,
Missisauga
ON L5T 2N1
Instruction Manual
1-888-543-6473
1-888-541-6474