Summary of Contents for odoland SP0810
- Page 1 FULL DRY SNORKEL MASK INSTRUCTION MANUAL Warm prompt : Diving is risky!Please read the product user manual before using our product.
- Page 2 HOW TO INSTALL, DISASSEMBLE THE BREATHING PIPE Installation: Disassembly: Make sure the top sealing ring of the mask is in good condition before installa- When disassembling, put the mask on your waist with your left hand, hold the tion, breathing pipe installed in place. You'll hear a click, indicates correct in- middle part of the breathing pipe in your right hand and gently pull it outward, stallation.
- Page 3 PRODUCT USE INSTRUCTIONS AND GUIDANCE 1.Check and confirm that the mask and breathing pipe are clean. Shake the breathing pipe ensure that the floating base of the pipe head can be moved up and down. 2.Confirm the mask top seal ring in intact, alignment the breathing pipe on the sealing ring at the top of the mask and press down hard, when the breathing pipe is press firmly, you'll hear a click.
- Page 4 PRODUCT WEARING INSTRUCTIONS 1. Put the mask breathing pipe on, 2. Release the two hoods from the 3. Pull up the hood and wear on the 4. Tighten the bottom hood so that pay attention to the installation in lower ends and lift the headband so back of the head,press the mask to two sides are tight and comfortable place.
- Page 5 MAINTENANCE TIPS 1.After using the mask please rinse it with fresh water, and place it in a cool place to dry naturally. After using it in seawater, it is best to soak it in warm water for 15 minutes and then clean it to prevent corrosive salt scale produce. 2.Please do not expose to the sun.
- Page 6 SNORKELING SAFETY TIPS These tips can help you prevent accidents while snorkeling 1. This product can only be used in accordance with the product manual. Incorrect use of products or matching other diving prod- ucts may result in injury or death. 2.
Need help?
Do you have a question about the SP0810 and is the answer not in the manual?
Questions and answers