Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Jinko Solar JKS-B51 BI Series
Summary of Contents for Jinko Solar JKS-B51 BI Series
- Page 1 JKS-B51XXX-BI Series Battery System Jinko Solar Residential Energy Storage User Manual Jinko Solar Co., Ltd No.1, Jinko Road, Shangrao Economic Development Zone Shangrao City, Jiangxi Province, 334100, P.R. China W:www.jinkosolar.com BESS_AU@Jinkosolar.com...
- Page 2 About this Document This document describes the installation, electrical connection, operation, commission, maintenance and troubleshooting of JKS-B51XXX-BI Series Battery System (hereafter Product Overview simply put JKS-B51XXX-BI). Before installing and operating JKS-B51XXX-BI, ensure that 1.1 Intended Use you are familiar with product features, functions, and safety precautions provided in this 1.2 Appearance document.
-
Page 3: Product Overview
Product Overview 1.1 Intended Use Name Color Description Each JKS-B5150-BI consists of 50Ah cells which form 51.2V voltage battery module and LED 1 Blue 0%-25% sixteen serial connection (1P16S).Two to ten JKS-B5150-BI can be connected in parallel and extend the capacity and power of energy storage system. The same type of cell and LED 2 Blue 26%-50%... -
Page 4: Basic Security
Safety 2.2.2 Operation Precautions Safety information contains in this section must be observed at all times when working Do not touch the PACK with wet hands. on or with batteries. For safety, installers are responsibility to familiarize themselves with Do not disassemble the PACK without permission. this manual and all warnings before installation. -
Page 5: Storage And Transportation
Storage and Transportation 3.1 Storage Requirements Ø Place the PACK follow the identification on the packing case during storage. Ø Do not put the PACK upside down or sidelong. Ø The defective PACK needs to be separated from other PACKs. Ø... -
Page 6: Installation Environment
Installation Ø Ensure to read the Guidance before installation in order to understand Wall product information and safety cautions; Ø Operators should be well trained technicians and fully understand the whole photovoltaic system, grid network, working principle and national regional standards; Ø... -
Page 7: Installation Procedures
It is recommended to wear the following safety gear when dealing with the PACK. Wall Mounted Installation Safety Goggle Safety Shoes Insulated Glove 4.4 Installation Procedures Pre-installation Check Check the PACK package before open it. If any abnormity is Check the package detected, do not open the Package and contact your distributor. -
Page 8: Electrical Connection
4.5 Electrical Connection Floor Standing Installation Do not forget wear ESD wrist strap and gloves, safety gloves and goggles. WARNING Terminal Definition: Fig 4.8: Terminal definition Serial Item Quantity Specifications Symbol Number Fig 4.7:Multiple JKS-B5150-BI with base installation process Communication Port IP67 Rj45 water proof connector PCS Step 1: Assemble the wall hangers together. - Page 9 Communication Interface Definition: Note: The battery is not allowed to be installed in the running state, and all the RUN lights of battery modules should be off before installation. RS485&CAN Crystal Plug Definition: To ensure system security, do not forget to install ground wire. For the power lines connected to PCS, the positive power line is drawn from the top Item Crystal Head Picture...
-
Page 10: Power Off
Power On and Off the Battery The installation and use of batteries involve much specialized Power on the PACK by PCS Ø knowledge. Therefore, technicians should be given appropriate technical training and obtain operational certificates in compliance with local laws Make sure the wiring harnesses are well Connect the battery and PCS. - Page 11 Maintenance Guide 6.1 Preparation 1. Check CAN connection Interior CAN Communication loss between two Batteries, CAN Ø Tools like safety gloves, cross head driver and socket wrench should be prepared. communication between connection between Linkin and Ø Turn off and turn on new PACK. failure two parallel.
-
Page 12: Technical Specifications
Appendix I Technical Specifications 7.1 LED Indication Control Mechanism Functional parameters of JKS-B5150-BI energy storage system are as shown below: LED Light Definition Items Specification SOC Indication RUN/ALM Battery Module JKS-B5150-BI (2.56kWh, 51.2V, 28kg) Status Items Remark LED1 LED2 LED3 LED4 LED5 Nominal/Rated Capacity... - Page 13 Over charge Mos high RUN/ALM light and over RUN/ALM light temperature (t=1S) (t=1S) flicker green discharge flicker green alarm protection Mos high RUN/ALM light Charging temperature (t=1S) flicker green current limit RUN/ALM light protection (t=1S) does not flicker green High respond temperature RUN/ALM light...
-
Page 14: Product Description
Type RUN/ALM light Model JKS- JKS- JKS- JKS- JKS- inconsistenc (t=1S) flicker red Difference B51300-BI B51350-BI B51400-BI B51450-BI B51500-BI y of PACK Batteries RUN/ALM light failure Parallel stays red protection Number of Voltage Module sampling RUN/ALM light anomaly stays red protection Produce Name Lithium Ion Battery... - Page 15 Battery System Weight (kg) Model Name JKS-B51100-BI JKS-B51150-BI JKS-B51200-BI Pack Pattern (1P16S)2P (1P16S)3P (1P16S)4P Rated Capacity(Ah) IFpP/41/150/102/[ IFpP/41/150/102/[ IFpP/41/150/102/[ Battery Designation (1P16S)2P]M/- (1P16S)3P]M/- (1P16S)4P]M/- Rated Energy(kWh) 10+50/90 10+50/90 10+50/90 Parallel Number of 1.Constant 1.Constant 1.Constant Module current 50A current 75A current 100A charging to 54V;...
- Page 16 Battery System Weight (kg) Model Name JKS-B51250-BI JKS-B51300-BI JKS-B51350-BI Pack Pattern (1P16S)5P (1P16S)6P (1P16S)7P Rated Capacity(Ah) IFpP/41/150/102/[ IFpP/41/150/102/[ IFpP/41/150/102/[ Battery Designation (1P16S)5P]M/- (1P16S)6P]M/- (1P16S)7P]M/- Rated Energy(kWh) 11.5 13.8 16.1 10+50/90 10+50/90 10+50/90 Parallel Number of Recommend 1.Constant current 100A charging to 54V; Module Charging Method 2.Constant current 10A charging to 55V;...
- Page 17 Battery System Weight (kg) Model Name JKS-B51400-BI JKS-B51450-BI JKS-B51500-BI Pack Pattern (1P16S)8P (1P16S)9P (1P16S)10P Rated Capacity(Ah) IFpP/41/150/102/[ IFpP/41/150/102/[ IFpP/41/150/102/[ Battery Designation (1P16S)8P]M/- (1P16S)9P]M/- (1P16S)10P]M/- Rated Energy(kWh) 18.4 20.7 10+50/90 10+50/90 10+50/90 Parallel Number of Recommend 1.Constant current 100A charging to 54V; Module Charging Method 2.Constant current 10A charging to 55V;...
Need help?
Do you have a question about the JKS-B51 BI Series and is the answer not in the manual?
Questions and answers