Use eye, ear, and face protection. Always wear ANSI-approved impact safety goggles. Wear a full face shield if you are producing metal filings or wood chips. Wear a NIOSH-approved dust mask or respirator when working around metal, wood, and chemical dusts and mists. Page 2 REV 07j SKU 46376...
Page 3
It must be under- stood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator. Page 3 SKU 46376...
Before Use. Before the first use, and once a month following, put a few drops of oil on the Driving Shaft Set (#12) bearings. Page 4 SKU 46376...
Page 5
Note: Although this manual primarily deals with rock/gemstone tumbling, you can use this Tumbler to work with metal and metal jewelry (without gemstones). This Tumbler may be Page 5 REV 02i,02k SKU 46376...
Page 6
You should see a definite shine in a few moments. If they shine, clean the Rubber Barrel (#22) and you are ready for the last step. If not, pre-polish and check in 24 hrs. Page 6 REV 07l SKU 46376...
Rubber Barrel (#22) is clean so that it doesn’t slip on the rollers. Wipe it with a soapy cloth, then wipe it clean with a damp cloth, and dry thoroughly. Do not use liquid cleaners or solvents. Page 7 SKU 46376...
Page 8
Bracket Barrel Lid Motor Fan Boot Gasket Ventilating Cover Inner Lid Rubber Foot Driving Pulley Bolt Belt NOTE: Some parts are listed and shown for illustration purposes only and are not available individually as replacement parts. Page 8 SKU 46376...
AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO. Page 9 SKU 46376...
This warranty gives you specific legal rights and you may also have other rights which vary from state to state. 3491 Mission Oaks Blvd. • PO Box 6009 • Camarillo, CA 93011 • (800) 444-3353 Page 10 SKU 46376...