Installation - AEG DI 8610 Operating And Installation Instructions

Installation - Fig. 6-7-8
Expansion plugs are provided to secure the hood to most types of
ceilings. However, a qualified technician must verify suitability of the
materials in accordance with the type of ceiling. The ceiling must be
strong enough to take the weight of the hood.
During electrical connection ensure the power supply is disconnected
at the domestic main switch.
• Adjust extension of the hood support structure, as the final height of
the hood depends on this, and remember that with installation
completed the hood must be at least 60 cm above the cook-top for
electric cookers and 75 cm for gas or mixed cookers.
• Fix the two sections of the structure using 8 screws (2).
• Place the ceiling hole diagram directly above the cook-top (3 - the
center of the diagram must match the center of the cook-top and
the edges must be parallel to the sides of the cook-top – the side of
the diagram with the wording FRONT corresponds to the control
panel side). Prepare the electrical connection.
• Drill as shown (6 holes for 6 wall plugs – 4 plugs for fixture), screw
the outer screws leaving a space of about 1 cm. between the screw
head and the ceiling (4).
• Fit an exhaust pipe inside the truss (5) and connect it to the motor
compartment connection ring (exhaust pipe and fixing brackets are
not supplied).
• Hook the frame onto the 4 screws (6 - see also step 4).
CAUTION! The side of the truss with connection box corresponds
to the side of the control panel with hood assembled.
• Tighten the 4 screws (7).
• Insert and tighten another 2 screws in the remaining free holes (8)
for secure fixing.
• Carry out the electrical connection (9) to the mains power supply,
only turn on the power supply upon completion of assembly.
• Hook the hood onto the truss (10) , ensuring it fits properly – to
hook the hood onto the truss partially tighten 4 screws (see also
step 12).
• Secure the hood to the truss using two screws (11); this will also
help center the two sections.
• Tighten the 4 screws securing the truss to the hood (12).
• For extractor versions (13A), connect the other end of the exhaust
pipe to the flue.
For filter versions (13F), fit deflector F to the truss and secure it to
the bracket supplied using 4 screws, then connect the exhaust pipe
to the connection ring located on the deflector.
89