Table of Contents
Advertisement
Prior to setting this feature:
1 Consult the user manual of your VCR or DVD recorder to check if and how
recorder control is supported. Most Philips VCR and DVD recorders support one
of the two recorder control options, i.e. Prepare Record and Record Link.
2 Check that your TV and VCR or DVD are both fitted with two SCART sockets.
3 Incorporate your receiver in your existing installation as described below:
to AC outlet
Cable Wall socket
TV set
EXT 2
• Connect the cable from the cable wall socket to the "RF In" socket of your
Digital-Receiver.
• Connect the "TV" SCART socket of your Digital-Receiver to the EXT1 SCART
socket of your TV using the SCART lead supplied with your Digital-Receiver.
• Connect the "VCR/DVD" SCART socket of your Digital-Receiver to the EXT2
SCART socket of your VCR (called "IN" or "DECODER") using a SCART lead.
• Connect the EXT1 SCART socket of your VCR (called "OUT") to the EXT2
SCART socket of your TV using a SCART lead.
4 Plug all your equipment, excluding your Digital-Receiver, into the mains.
Read section Quick installation to proceed with the channel scan if not already done.
With this connection set up:
- You can watch digital TV while you record analogue TV.
- You can watch analogue TV while you record digital TV.
- You can record the digital TV channel you are watching.
Some VCR or DVD recorders need to be in standby to use the Prepare Record or
Record link feature. Refer to your VCR or DVD user manual.
Cable Receiver
Supplied
EXT 1
Supplied
VCR/DVD
EXT 1
ANT IN
EXT 2
ANT OUT
EN
85
Advertisement
Table of Contents
