Neo-Neon FCB-VI-OX0125L-6FT-12P Instruction Manual

The Instruction Manual for 6' RGB Cone Tree
Model No.: FCB-VI-OX0125L-6FT-12P
Input Voltage: 120V~60Hz 1.5A Max.
Output: 12V 6.0A
CAUTION:
Use only UL Listed Class2 12V DC Power Supply.
This seasonal product is not intended for permanent installation.
To reduce the risk of fire or electric shock, do not attempt to replace lamps or modify string.
Always unplug this product before installing.
To reduce the risk of fire and electric shock: Do not install on trees having needles, leaves or branch
coverings of metal ormaterials which look like metal.
To reduce the risk of fire and electrical shock: Do not mount or support strings in a manner that can cut or
damage wireinsulation.
IMPORTANT SAFETY INSTRUCTIONS
When using electrical products, basic precautions should always be practiced including the following:
1.Please read this manual before use;
2.When the temperature is below ≤ 50°F (10°C), please do not directly straighten the lamp body because the
lamp body is hard,so as not to damage the lamp body. It is recommended to connect the power supply to
light the lamp body for 8~10 minutes.When the lamp body is soft, Can be straightened and assembled.
3.In order to reduce the deformation of the lamp body, it is recommended to vertically pull down the straight
lamp bodyduring assembly. Do not forcibly straighten the lamp body when the lamp body is twisted.
4.The lamp beads are not replaceable;
5.The external wires of the product cannot be replaced. If the external wires are damaged, do not use them.
6.Do not connect with other products;
7.Products can be used indoors and outdoors;
8.Do not place the product near gas, electric heaters, fireplaces, candlesticks, or other similar sources of heat;
9.The products are electronic products, non-toy products, please do not play for children, please keep them
out of reach ofchildren, so as not to cause fire, burns, personal injury, electric shock and so on;
10. Avoid piercing the lamp body with sharp objects;
11.After the product is installed, do not hang other objects on the product;
12.Do not cover flammable materials when using the product;
13.Please check the integrity of the product before use or before using it. If the product is damaged, please do
not use it. If it isdamaged, please do not use it.
14.The product must be connected to the correct voltage;
15.When a fault occurs, please turn off the power immediately. Hold the plug when the power is off, and do
not pull the powercord;
16.If the operation is not carried out in accordance with the precautions, the manufacturer will not be
responsible.
Page 1 / 3