Advertisement
Table of Contents
`
Contents
Introduction ......................................................................................................................................................... 1
Wired Water Leak Sensor (Orc-Leak-Wd-Wh) .................................................................................................... 2
Specification .................................................................................................................................................... 2
Installation ....................................................................................................................................................... 2
Wiring To Orcomm Smart Touch Screen (V1 Pre 6/2018 Models) .................................................................. 3
Wiring To Orcomm Smart Touch Screen (V2 8/2018 Onwards)....................................................................... 3
Wiring To Orcomm Orc-Hagw (V1) ............................................................................................................... 4
Testing The Sensor ........................................................................................................................................... 4
More Information Links ....................................................................................................................................... 4
ORC-LEAK-WD-WH .......................................................................................................................................... 4
Smart Home ..................................................................................................................................................... 4
Introduction
This guide is designed to help understand orcomm offering for Water Leak detection via the
Smart Home system.
For further installation instructions, please refer to the Orcomm Smart Home Touch Screen
Installation manual available at www.orcomm.co.uk/downloads.
Leak Detection – Manual V1.0
Advertisement
Table of Contents
Related Manuals for Orcomm ORC-LEAK-WD-WH
Summary of Contents for Orcomm ORC-LEAK-WD-WH
- Page 1 ORC-LEAK-WD-WH ............................4 Smart Home ..............................4 Introduction This guide is designed to help understand orcomm offering for Water Leak detection via the Smart Home system. For further installation instructions, please refer to the Orcomm Smart Home Touch Screen Installation manual available at www.orcomm.co.uk/downloads.
- Page 2 Wired water leak sensor (ORC-LEAK-WD-WH) Low Profile Water sensors that can be installed in areas vulnerable to water leak. Specification • L64 x W16 x H13mm (excluding wire) • Housing Material – ABS White • Working Voltage 5 – 12V DC (Red is Positive and White is Ground) •...
- Page 3 Wiring to Orcomm Smart Touch Screen (V1 pre 6/2018 models) The below can be followed when installing with monitors Version 1. Touch Screen Monitor will need to be set in “NO” mode Voltage will measure 4 to 5V DC in standby mode When Zones 1 –...
- Page 4 Wiring to Orcomm ORC-HAGW (V1) The below can be followed when installing with orcomm Smart Home Gateway. The ORC-HAGW must be set to monitoring Water Leak Stand by voltage will vary depending on set up – refer to ORC-HAGW manual.
Need help?
Do you have a question about the ORC-LEAK-WD-WH and is the answer not in the manual?
Questions and answers