Sercomm Genesis OC3505D Quick Installation Manual
Sercomm Genesis OC3505D Quick Installation Manual

Sercomm Genesis OC3505D Quick Installation Manual

Fwa outdoor cpe

Advertisement

Quick Links

OC3505D Genesis FWA Outdoor CPE
Quick Installation Guide
1

Overview

This product is an outdoor FWA CPE designed to support band 48.
2

Package Contents

Genesis FWA CPE
1.
Mounting Kit
2.
1 * Mounting Bracelet
2 * Holder
4 * Nut
4 * M6 Hex Bolt/Washer/Split Lock Washer
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Genesis OC3505D and is the answer not in the manual?

Questions and answers

Summary of Contents for Sercomm Genesis OC3505D

  • Page 1 OC3505D Genesis FWA Outdoor CPE Quick Installation Guide Overview This product is an outdoor FWA CPE designed to support band 48. Package Contents Genesis FWA CPE Mounting Kit  1 * Mounting Bracelet  2 * Holder  4 * Nut ...
  • Page 2 Interface The following figure illustrates the appearance of the device. Table 3-1 Descriptions of the interfaces and buttons Micro SIM Card Slot Insert the micro SIM card here. Reset Button This button is recessed; you need a pin or paper clip to depress ...
  • Page 3 Five LEDs - RSRP (> -85) dBm  Status LED On (Green) - Power on. (Green/Red) Off - No power. On (Red) - No SIM card. Error/Warning. Installation Step 1: Connect a standard CAT 5E or CAT 6 Ethernet cable to the LAN port of the de- vice Remove the water-proof cap from the device.
  • Page 4 2. Use the two circular holders and four nuts to secure the Genesis CPE to a pole. (8mm wrench driver required) 3. Keep the M6 hex bolts on the mounting bracket loosen for adjusting the direction of the Genesis CPE later. 4.
  • Page 5 Step 4: Power on Genesis CPE 1. Connect the Ethernet cable from the Genesis CPE to the OUT port on the PoE injector unit. 2. Connect the power cable to the PoE injector. 3. Connect the PoE injector power plug to a power source. 4.
  • Page 6 6. Manually adjust the Genesis CPE vertically and horizontally until you have obtained the best RSRP (-80) (this value is not guaranteed depending on installation location) and SINR (30 or higher) values. These values will refresh every 2 seconds. If SINR < 5 ...
  • Page 7 Technical Specification Table 5-1 Technical Specification Item Specification Dimension 307mm x 307mm x 77.8mm (Height x Width x Depth) Power PoE (Power Over Ethernet) Operation Temperature -40ºC ~ 55ºC Storage Temperature -40ºC ~ 70ºC LAN Port 1 * 10/100/1000BaseT (RJ45) LAN Port SIM Interface 1 * Micro SIM socket...
  • Page 8 Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital de- vice, pursuant to Part 15 of the FCC Rules.

Table of Contents