Advertisement
Quick Links
Isolation Transformer
Installation Guide
1. Place the Isolation Transformer in a
dry, indoor, location. The transformer
is not designed to be mounted
outdoors.
4. Locate the speaker cable from the
amplifier. Remove .75 in. (20 mm) of
the cable's outer jacket.
7. Insert the positive wire (usually
white or red) to the 1+ terminal, and
the negative wire (usually black) to the
1- connection. Tighten the 1+ and 1-
screws.
2. Transformer may be mounted to
a wall using mounting tabs. (The
transformer is heavy and must be
securely mounted to the wall.)
5. Remove .3 in. (8 mm) of insulation
from each wire.
8. Push the gray ring down until it
locks on the connector's body.
3. Locate the Neutrik NL3FC Speakon
connector. Remove the connector
from the bag.
6. Place the Speakon connector's blue
bushing on the amplifier cable.
9. Screw the blue bushing onto the
connector's body. The connector is
now assembled.
303-797-7500
www.clarksynthesis.com
Advertisement
Summary of Contents for Clark Synthesis Aquasonic Isolation Transformer
- Page 1 Isolation Transformer Installation Guide 1. Place the Isolation Transformer in a 2. Transformer may be mounted to 3. Locate the Neutrik NL3FC Speakon dry, indoor, location. The transformer a wall using mounting tabs. (The connector. Remove the connector is not designed to be mounted transformer is heavy and must be from the bag.
- Page 2 Isolation Transformer Installation Guide 10. Plug the amplifier cable connector into the transformer input. Make sure to turn the connector until it locks in place. 11. Repeat steps 3 - 9 to attach the Speakon connector to the Diluvio Speaker cable. Connect the positive wire (white) to the 1+ connection, and the negative wire (black) to the 1- connection.
Need help?
Do you have a question about the Aquasonic Isolation Transformer and is the answer not in the manual?
Questions and answers