Allo RemoteControl AVIDSEN 104250 BRICO Instructions

Advertisement

First type of receiver

1. Open the casing of your receiver. It is located next to your motor.
2. On the receiver circuit board, press the programming button (RF). Keep it pressed down.
The receiver LED light comes on (L1). Release the button
3. Within the next 10 seconds, press a button on your new remote control, release it. The
receiver LED blinks.
4. Wait 10 seconds.
5. Your new remote control is programmed.
Visit our Website: www.alloremotecontrol.com
AVIDSEN 104250 BRICO
INSTRUCTIONS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AVIDSEN 104250 BRICO and is the answer not in the manual?

Questions and answers

Summary of Contents for Allo RemoteControl AVIDSEN 104250 BRICO

  • Page 1 INSTRUCTIONS AVIDSEN 104250 BRICO First type of receiver 1. Open the casing of your receiver. It is located next to your motor. 2. On the receiver circuit board, press the programming button (RF). Keep it pressed down. The receiver LED light comes on (L1). Release the button 3.
  • Page 2 Second type of receiver: 1. Open the casing of your receiver. It is located next to your motor. 2. On the receiver circuit board, press the programming button (RX). Release the button. The receiver LED comes on. Wait 5 seconds. The receiver LED light turns off. 3.

Table of Contents