Page 1
OS 170 Fertilizer Spreader Owner’s Manual and Parts Book (Originating w/Serial Number 82-101) Model Number: Serial Number: Date of Purchase: N117080 Rev. A 08.05.17...
Page 3
All Loftness products have a one (1) year limited warranty. The XLB10 Grain Bag Loader has a two (2) year limited warranty. If any Loftness product is used as rental equipment, or in a commercial application, the limited warranty period is for only 30 days from the delivery date to the original customers.
It is also important that you fill out the Warranty Registration form(s) completely and return to Loftness so as not to void the warranty. Keep the owner’s manual and the entire documentation packet in the storage compartment provided with your fertilizer spreader.
It is the operator’s responsibility to be aware of • Periodically check all guards, shields and structural machine operation and work area hazards at all members. Replace or repair anything that could times. cause a potential hazard. OS 170 Fertilizer Spreader OM...
Keep chemical fertilizers away from children, pets, attention immediately! and unauthorized personnel. • Store chemical fertilizers in their original containers and securely closed. Be sure to read fertilizer manufacturers storage recommendations. • Dispose of empty fertilizer containers according to manufacturer’s instructions. OS 170 Fertilizer Spreader OM...
1 / 2 1# TO 4 1 / 2 # MAX Stay clear. N35383 Wear eye Part No. N35383 protection. N35380 Part No. N35380 WARNING Disengage all power before servicing or adjusting. N35391 Part No. N35391 OS 170 Fertilizer Spreader OM...
Connect surge breakaway chain to tractor. • Visually inspect the spreader for damage or missing The tractor draw bar and PTO must conform to ASAE parts. Contact your Loftness dealer if any parts need specifications shown in illustration below for proper PTO replacing. operation.
Pull pin (1) that secures the jack (2) to the frame and rotate into the storage position as show. Reinsert pin to secure. OS 170 Fertilizer Spreader OM...
(1) on the conveyor manifold out, and turn locked in the storage cradle and hydraulic to lock into place. hoses are secure before transport. If the tractor has a closed-center system, turn and push the red button (1) on the controller in. OS 170 Fertilizer Spreader OM...
If you would like to order a density scale for your mechanical ground drive model spreader, contact your Loftness dealer. NOTE: Cover opened for clarity. Loosen handle (1). Move the gate control lever (2) until the indicator (3) is at the proper setting.
Weigh spreader before and (Procedure continued on following page.) after test to determine amount actual amount of fertilizer applied. OS 170 Fertilizer Spreader OM...
Find the fertilizer density. See “Determining Product Density” on page 12. NOTE: If scale is not available, weigh 1 gallon (3.78 Liters) of the fertilizer and then multiply that by 7.5 to establish the product density. OS 170 Fertilizer Spreader OM...
CAUTION: Do not use a gate setting of 1.5 in. (3.81 cm) in high range. This could CAUTION: Do not exceed the rated gross cause undue stress on the hopper from a high weight of the spreader. conveyor speed. OS 170 Fertilizer Spreader OM...
Loftness is not responsible for costs or damages caused by misapplication of fertilizers. It is the responsibility of the operator to assure that the fertilizer is applied uniformly and correctly over the application area.
It is vital that they stay in order as IMPORTANT: DO NOT let the spreader sit for an this will facilitate the recording procedure. It extended period of time with material in may help to label each pan accordingly. the hopper. OS 170 Fertilizer Spreader OM...
Serial #_______________________ Date__________ Test#_______ Spread Pattern Test Results 40-90 ft. 40-90 ft. Driving Interval Driving Interval Recorded Vial Readings Spinner Blade Hole Location Rear Deflector Setting Gate Setting Range Spinner RPM Material Density Notes/Comments:___________________________________________________________________________________ ____________________________________________________________________________________________________ ____________________________________________________________________________________________________ OS 170 Fertilizer Spreader OM...
D - One half of driver interval width. Acceptable patterns will deliver one half of the desired application rate at distance equal to one half driving interval from centerline. This point will be at the middle of the overlap. OS 170 Fertilizer Spreader OM...
Retighen nuts when preferred dimension is reached. See Pattern also “Rear Deflector Adjustment” on page 25. If the shape resembles any of the undesirable patterns above, take the recommended corrective action described in the following chart. OS 170 Fertilizer Spreader OM...
(Procedure continued on following page.) To adjust rear deflector (1), loosen the nut and washer (2) on each side of deflector. Slide the deflector forward or back accordingly. Retighten hardware when deflector is in the desired position. OS 170 Fertilizer Spreader OM...
Retighten handle when angle is set. Repeat for opposite side. NOTE: Refer to “Bander Installation and Removal” on page 32 for installation and removal of the bander assembly. The bander will need to be removed when broadcast spreading. OS 170 Fertilizer Spreader OM...
Oil Leaks Bearings (Spinner, after Conveyor, Metering Gate, Mechanical each Ground Drive - if use) equipped) Chain Tension PTO Shaft Conveyor Every Safety Labels Wheels and Tires Every Bearing Set Screws Wheel Bearings Every Jack OS 170 Fertilizer Spreader OM...
(EP) rating. NOTE: Replace any broken or missing grease fittings. Be sure to clean fittings before greasing. NOTE: See “OS 170 Fertilizer Spreader Identification” on pages 6 and 7 for component location and identification. Location: Metering gate bearings (5, 6).
Page 37
Location: Drive shaft bearings (13, 14, 15). Location: Clutch shaft bearings (20, 21, 22, 23). (PTO drive models only). Clutch assembly elbow fittings (24, 25). Interval: Every 8 hours of operation. (Mechanical ground drive only.) Interval: Every 8 hours of operation. OS 170 Fertilizer Spreader OM...
4 hours. Wipe off excess oil before reinstalling. Location: Wheel bearings - both tires (27). Interval: Every 500 hours of operation. NOTE: See “Wheel Bearing Maintenance” for more information on wheel bearing maintenance. OS 170 Fertilizer Spreader OM...
Install and align sprocket with chain on gate, be sure gate is closed all the way. Tire Inflation Check tire inflation pressure. Set correct inflation pressure for tire per table. Tire Size Inflation Pressure 11L-15 44 psi OS 170 Fertilizer Spreader OM...
Fertilizer build-up on floor and around Clear fertilizer build up. metering gate. Spinner speed does not increase. Low tractor hydraulic flow. Increase flow from tractor. OS 170 Fertilizer Spreader OM...
Page 42
Controller in test mode. Exit test mode. Rate set to manual. Set rate to automatic mode. Conveyor ratches. Rate set too low. Increase rate. Decrease gate opening and adjust spreader constant. Speed too slow. Drive faster. OS 170 Fertilizer Spreader OM...
Page 43
Wrong sheaves and V-belt are being Use only sheaves and deep-groove used. belts. Bander not throwing product at Bander deflector(s) not set properly. Adjust and set bander deflector(s). correct or consistent distance(s). See “Bander Operation” on page 26 for instructions. OS 170 Fertilizer Spreader OM...
41,39 Detail C See Detail B QTY. PART # DESCRIPTION N105368 ELBOW, 90 DEG -6MJIC -6MBSPP N53062 HOSE, 3/8 X 14 -6FJX -6FJX N29078 ELBOW, 90 DEG - 6MJIC - 6FJIC N28847 ADAPTER, -6MJIC -6MBSPP OS 170 Fertilizer Spreader OM...
Page 55
NUT, LOCK 3/8" SER FLG N102127 BRACKET, HOSE HOLDER 4195 BOLT, 3/8" X 1" GRADE 5 N50815 BOLT, 3/8" X 1" SS SER FL GR 5 N73940 NUT, LOCK 3/8" SER FLG SS N101044 PLATE, SPINNER MOTOR 50' OS 170 Fertilizer Spreader OM...
Parts Identification Conveyor Drive, Hydraulic (Pressure) (Tank) Detail A (Pressure) Detail A (Tank) * See page 52 for parts breakdown of Item 10 (N102345). OS 170 Fertilizer Spreader OM...
Page 59
SPROCKET, 50B42 1" BORE N11825 COUPLER, 1/2" MALE PIONEER N108462 HARNESS, CONTROL RAVEN 16 PIN N150788 HARNESS, CONTROL RAVEN 22 PIN N150789 HARNESS, CONTROL RAVEN 37 PIN N113354 SENSOR, SPIN SPEED N105370 DENSITY SCALE, FERTILIZER OS 170 Fertilizer Spreader OM...
PLATE, ADJUSTER 4569 BOLT, CARRIAGE 3/8" X 5" SS FT N129000 BRACKET ASM, SPREADER DRIVE N50815 BOLT, 3/8" X 1" SS SER FL GR 5 * See page 56 for parts breakdown of Item 39 (N109201). OS 170 Fertilizer Spreader OM...
Page 63
WASHER, 3/4" FLAT 4517 BOLT, 3/4" X 2" BOLT GR 5 N42066 CHAIN, #2050 X 37.50 7187-03 KEY, 1/4" X 1-1/2" N109201 CLUTCH ASM * See page 56 for parts breakdown of Item 39 (N109201). OS 170 Fertilizer Spreader OM...
25 Ft. Mechanical Drive 204017 - Distance Mechanical Drive (Used with Bander only) Part No. N47482 (sides); N55874 (front) Part No. N49815 (Decal length shortened to fit on page.) DISTRIBUTOR BELT Part No. N117054 WRAP N49815 OS 170 Fertilizer Spreader OM...
Need help?
Do you have a question about the OS 170 and is the answer not in the manual?
Questions and answers