Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Planet Audio P10AW
Summary of Contents for Planet Audio P10AW
- Page 2 Thank you for choosing our product! Please read the instructions carefully so you will know how to operate your product properly. If there are any technical questions, please contact: Customer care: (805) 751-4854 & Live chat Online support: www.planetaudio.com/support IMPORTANT Please enter below the Serial No.
-
Page 3: Table Of Contents
When first unpacking your new amplified subwoofer, please check first the package contains all of the items listed below. If something is missing, contact the store where you purchased the product. • 1 x P10AW amplified subwoofer • 1 x High level input wire harness •... -
Page 4: Important
Important Read and understand all instructions before you use your product. If you do not follow the instructions in this manual, we are not responsible for any resulting personal injury or damage to property. This will also void the warranty. Important Safety Precautions •... -
Page 5: Panel Controls And Features
Panel Controls and Features 11 10 9 1. Power Terminals GND: Connect to the closest point on the chassis of your vehicle. REM: Connect to the remote output wire of your head unit. No need to make the remote connection if you use high-level input connection and auto power on function is activated. -
Page 6: Subwoofer Setup Procedure
8. Low Pass Filter (LPF) Use this control to define the frequency range you want the subwoofer to receive. The subwoofer will only receive the frequencies below the one you set to reproduce sound. Tip: If the other speakers of your audio systems are weak on the mid frequencies, set the LPF control relatively high. -
Page 7: Protection Mode
Protection Mode When protection mode triggers, the red LED on the subwoofer turns on and the subwoofer shuts down. One of the following reasons can trigger protection mode: input overload, short circuit and extremely high temperature. When the red LED turns on, take the following measures. •... -
Page 8: Wiring
Wiring See the section “Installation Precautions” on page 3. For safety, disconnect the negative terminal of the vehicle battery prior to wiring. Use only high quality wires for reliable installation to minimize signal or power loss. Make sure wires are not squeezed or damaged by sharp edges. Use rubber bushings for penetrations. -
Page 9: Power Connection
Black Gray To the speaker wires of your head unit To metal frame Blue White of the vehicle • Using the supplied high-level input wire harness, fasten the black wire to the metal frame of your vehicle (for signal noise prevention), and connect the other four colored wires to speaker output wires of your head unit. -
Page 10: Subwoofer Level Control Connection
The REM teminal connection is used to automatically turn on or off the subwoofer every time the connected head unit is turned on or off. If your head unit does not have the remote output wire, connect the REM terminal on the subwoofer to the ignition switch wire of your vehicle. - Page 11 Problem Solution Protection/Red LED lighting Turn down volume on your source unit to prevent overdriving. Reset the subwoofer by turning it off and on again (see the section “Protection Mode” on page 6 for more details). If the red LED still lights up, the subwoofer is faulty and needs servicing.
-
Page 12: Specifications
Specifications Audio Output power ..........max. 1000W Driver size ............ 10” Speaker impedance ........2.6Ω Total harmonic distortion (THD) ....<4% Frequency response ........20Hz - 150Hz Signal-to-noise ratio ........68dB Input sensitivity ..........50mV (low level/RCA); 0.3V (high level) Low pass filter (LPF) ........