LG LDT779 Series Owner's Manual page 22

us_main.book.book Page 22 Thursday, April 21, 2022 4:58 PM
22 INSTALLATION
6
If a water leak is detected, press and hold the
Start button for 3 seconds to cancel the wash
cycle and automatically drain the water from
the dishwasher. Tighten all water connections
and run another cycle. Repeat until no leaks
are detected.
7
Replace the lower cover.
CAUTION
• Only install the lower cover provided with the
dishwasher. Do not install cabinet baseboard
as it may cause noise and leakage.
Installation Check Error Codes
Refer to the chart below before calling for service.
Error Code Possible Cause and Solution
Drain hose is kinked or pinched.
OE
• Feed the drain and water
supply hoses through the hole
under the sink. Then gradually
slide the dishwasher into the
cabinet while pulling on the
hoses under the sink to take up
any slack. This helps avoid
kinking the hoses or trapping
them beneath the dishwasher.
Drain hose is connected to the
disposal without removing the
knockout plug.
• Remove the knockout plug
from the disposal.
Waste tee or disposal is clogged.
• Remove knockout plug on the
waste tee or disposal.
Error Code Possible Cause and Solution
Water supply line is kinked
IE
under dishwasher.
• Feed the drain and water
supply hoses through the hole
under the sink. Then gradually
slide the dishwasher into the
cabinet while pulling on the
hoses under the sink to take up
any slack. This helps avoid
kinking the hoses or trapping
a them beneath the dishwasher.
House water supply is not turned
on.
• Turn the water faucet on.