Advertisement
To ensure the successful installation of your IS-5041 STB, read and follow the step-by-step instructions below.
1. Do you have all of the necessary equipment?
a. IS-5041 STB
b. Remote Control (This remote control is already programmed to operate your STB. Instructions on how to
program your remote to operate your TV or other devices are available from your service provider.)
c. HDMI Cable
d. Power Cord
Power Cord
HDMI Cable
Advertisement
Table of Contents
Summary of Contents for Innovative systems IS-5041
- Page 1 To ensure the successful installation of your IS-5041 STB, read and follow the step-by-step instructions below. 1. Do you have all of the necessary equipment? a. IS-5041 STB b. Remote Control (This remote control is already programmed to operate your STB. Instructions on how to program your remote to operate your TV or other devices are available from your service provider.)
- Page 2 Make sure your TV is turned off. Connect the HDMI cable from the HDMI port on the back of the STB to the HDMI input on your TV. Turn on your TV. Make sure that your TV is set to the proper input. Plug one end of the STB power cord into the STB, and then the other end into the power outlet.
- Page 3 Go to your Wi-Fi access point and start WPS. If you don’t know what your Wi-Fi access point is, ask your service provider for help. [Instructions here are dependent on the type of Wi-Fi access point. These instructions are for a IS-5112W or IS-5041W access point STB.] To start WPS, press Menu on the access point settop box remote control.
Need help?
Do you have a question about the IS-5041 and is the answer not in the manual?
Questions and answers