Connections; Connecting The Power Cord; Connecting The Cables - Mitsubishi Electric TSD-AT1519-MN User Manual

4. Connections

Connecting the power cord

Connect the input power cable to the terminal block on the rear side of the touch panel monitor.
Before connecting the signal cable, please turn off the power to this device, your computer and peripheral
devices.A dedicated power cable is not provided with this device.
Use a 0.75mm
Remove the insulating plate secured with a screw from the top of the power supply connector prior to connection.
In the interests of safety, secure the insulating plate again with the screw after connection.
Do not use with power voltages other than it indicated. It causes the fire and the electrical shock.

Connecting the Cables

Fix the cables surely with each fixed screws.
Before connecting the signal cable, please turn off the power to this device, your computer and peripheral devices.
It is recommended to connect directly with the computer without the USB hub, etc. when connecting USB.
Serial Port
RS232C
USB
USB Port
DVI output
VGA
output
Computer
1: Video signal cable (mini-D-Sub 15pin)
2: Video signal cable (DVI-D)
6
power cable or thicker.
2
1 2
DVI
VGA
input
input
Mini D-Sub DVI-D
15pin
24V DC
power supply
3 4
USB RS-232C
USB D-Sub
type B 9pin
3: Touch communication cable (USB type B)
4: Touch communication cable (D-Sub 9pin)
Insulating plate
FG G GND 24V N 2
Earth
GND
−
24V
＋
Video signal cable is
connected to only 1
or 2.
Touch communication
cable is connected to
When connecting the
only 3 or 4.
USB cable, secure the
touch communication
cable with the cable
clamper and screw
provided to prevent the
connector from being
disconnected.