Advertisement
Quick Links
Introduction:
The 170944 Intek Steamer Stand is shipped in a compact, knockdown form. Assembly on site
is required before attempting to mount the steamer(s). The instructions below will guide you
through the process. All of the hardware required to assemble the stand and mount the
steamer(s) is included.
1.0
Stand Assembly
1.1
Determine the shelf position locations most appropriate to the location. There are two
shelves supplied with the stand and both must used to provide proper stability. The lower shelf
always mounts in the bottom position. The upper shelf mounts in one of four positions,
depending upon whether a single steamer is being mounted or a pair of steamers are being
double-stacked. The upper shelf always mounts in the topmost position when a pair of
steamers are mounted.
1.2
The above figure shows the shelf orientation for a single steamer, where the cutout in
the lower shelf is turned to the back of the stand. For a double-stack stand, turn the shelf so the
cut-out faces to the front.
I
NSTRUCTION
Intek Steamer Knockdown Stand
Assembly and Steamer Mounting
Page 1
S
HEET
170720 Rev. B
Advertisement
Summary of Contents for Unified Brands 170944
- Page 1 Assembly and Steamer Mounting Introduction: The 170944 Intek Steamer Stand is shipped in a compact, knockdown form. Assembly on site is required before attempting to mount the steamer(s). The instructions below will guide you through the process. All of the hardware required to assemble the stand and mount the steamer(s) is included.
- Page 2 Attach each shelf (Item 2) to the stand with eight 2” hex-head screws (Item 4), inserting the screws through the legs. Install a washer (Item 5) under the head of the screw and under the dome nut (Item 6) holding the screw, as shown below. Square up and tighten the stand before installing the steamer(s).
- Page 3 If the stand is to have casters or flanged feet, they are supplied in separate kits. See the instructions provided and install the casters or flanged feet in place of the bullet feet. Steamer Installation Prepare the Intek steamer by loosening and removing the four short legs and the four screws on the base.
- Page 4 Set the Intek steamer on the stand upper shelf as shown and re-attach the drain pan rails using four 3/8-16 5/8” hex head machine screws (Item 9) and four 3/8 washers (Item 10). Start the screws into the bottom of the steamer, but do not fully tighten them until step 2.4. Steamer with legs removed Drain Pan...
- Page 5 Tighten all four screws holding the drain pan rails to the shelf. Install hole plugs in any unused holes in the shelf that are visible after the steamer has been attached. If a second steamer is provided, install it on the lower shelf in the same manner as the first, using steps 2.1 through 2.4.