Advertisement
To Light
3
Model 512A708
1. ALWAYS LIGHT HEATER OUTDOORS IN AN OPEN
AREA. Starter flame will burn approximately 2-3 feet
under normal lighting conditions.
2. Open canopy (Fig. 1) and remove snuffer from heater
head (Fig. 4).
3. Hold heater upside down until a 2" diameter spot of
fuel appears. (Fig. 5) In temperature below freezing
spot should be 3" to 4"
4. Turn heater right side up and with canopy open light
fuel spot. (Fig. 6)
5. Allow starter flame to burn until flame completely
goes out.
6. Close canopy. Heater should reach maximum output
in 15-20 minutes, slightly longer for new heater. With
new heater there may be slight odor of hot paint.
7. If no heat is felt after 15 minutes, open canopy and
repeat lighting procedure.
CAUTION: Never attempt to repeat lighting procedure
until •starter flame has gone out.
Snuffer
Heater
Head
Adjustment Lever
Canopy
(Fig. 4)
Models 513A708,
1 . ALWAYS LIGHT HEATER
will burn
AREA. Starter flame
conditions.
under normal lighting
2 ' Open canopy (Fig. 1)
head (Fig. 4).
3. Set red adjustment lever
4. Hold heater upside down
fuel appears on Model 513A708
Model 515A708). In temperatures
crease diameters of spots by 1"
5. Turn heater right side up and with
canopy open light fuel spot. (Fig. 6)
6. Allow starter flame to burn until
flame completely goes out.
7. Close canopy. Heater should reach
maximum output in 15-20 minutes,
slightly longer for new heater. With
new heater there may be slight odor
of hot paint.
8. If no heat is felt after 15 minutes,
open canopy and repeat lighting
procedure.
CAUTION: Never attempt to repeat
lighting procedure until starter flame
has gone out.
(Fig. 5)
515A708
OPEN
OUTDOORS IN AN
approximately 2-3
from heater
and remove snuffer
to "Start"
until a 2" diameter spot
(3" diameter spot on
below freezing in-
feet
of
Starter
Flame
(Fig. 6)
Advertisement
