Table of Contents
Advertisement
Configuring Camera Sound Settings (Sounds)
Procedure
[MENU] * Set Up Tab * Sounds
Startup
Half Shutter
Shutter
Operation
Operation (
)
=
Play (
)
=
• Setting a volume level of 0 mutes output.
Specifying the File Name Serial Number Generation Rule
(File No.)
Procedure
[MENU] * Set Up Tab * File No.
Use the following procedure to specify the rule that governs generation of the serial
number used in file names (page 94).
Tells the camera to remember the last used file number. A new file will
be named using the next sequential number, even if files are deleted or
if a blank memory card is loaded. If a memory card is loaded and that
Continue
card already has files stored on it and the largest sequential number in
the existing file names is greater than the largest sequential number
remembered by the camera, numbering of new files will start from the
largest sequential number in the existing file names plus 1.
Restarts the serial number from 0001 whenever all files are deleted or
when the memory card is replaced with a blank one. If a memory card
Reset
is loaded and that card already has files stored on it, numbering of new
files will start from the largest sequential number in the existing file
names number plus 1.
Specifies the startup sound
Sound 1 - 5: Built-in sounds (1 through 5)
Off: Sound off
Specifies the sound volume. This setting is also used as the
audio level during video output (page 64).
Specifies the volume of movie and Audio Snapshot audio
output. This volume setting is not used during video output
(from the USB/AV port).
98
Other Settings (Set Up)
Advertisement
Table of Contents
