Table of Contents
Advertisement
Problem
Though available lighting is
bright, the faces of people in
the image are dark.
Subjects are too bright when
shooting images in a
seashore or ski area.
Digital zoom does not work.
The zoom bar indicates zoom
only up to a zoom factor of
3.0.
The image is out of focus
during movie recording.
Playback
The color of the playback
image is different from what
appears on the monitor
screen when shooting.
Images are not displayed.
I can't edit images (resizing,
trimming, keystone correction,
color restoration, rotation,
date/time editing).
B
Not enough light is reaching the subjects. Change the flash mode setting to "
synchro flash (page 71), or use adjust EV shift to the + side (page 106).
Sunlight reflected by water, sand, or snow, can cause underexposure of images. Change the flash mode
setting to "
" (Flash On) for daylight synchro flash (page 71), or use adjust EV shift to the + side (page
106).
1) The digital zoom setting may be turned off. Turn on digital zoom (page 70).
2) Time stamping may be turned on, which will cause digital zoom to be disabled. Turn off time stamping
(page 115).
1) Focusing is not possible because the subject is outside the focus range. Shoot within the allowable
range.
2) The subject you are shooting may be difficult to focus (page 67).
3) The lens may be dirty. Clean the lens (page 32).
Sunlight or light from another source may be shining directly into the lens when you are shooting. Position
the camera so sunlight does not shine directly into the lens.
This camera cannot display non-DCF images recorded onto a memory card using another digital camera.
Note that you cannot edit the following types of imagess.
• Images created with MOTION PRINT
• Movies
• Images recorded with another camera
Possible Causes and Action
222
" (Flash On) for daylight
APPENDIX
Advertisement
Table of Contents
