Subscribe to Our Youtube Channel
Related Manuals for Insignia NS-PFT28BK3
Summary of Contents for Insignia NS-PFT28BK3
- Page 1 USER GUIDE 28" Square Fire Table - Black NS-PFT28BK3 Before using your new product, please read these instructions to prevent any damage.
-
Page 2: Table Of Contents
Contents IMPORTANT SAFETY INSTRUCTIONS ..............3 Features . -
Page 3: Important Safety Instructions
28" Square Fire Table - Black IMPORTANT SAFETY INSTRUCTIONS DANGER If you smell gas: 1 Shut off gas to the appliance. 2 Extinguish any open flame. 3 If odor continues, keep away from the appliance and immediately call your gas supplier or fire department. - Page 4 DANGER Failure to comply with the precautions and instructions provided with this fire table can result in death, serious bodily injury, and property loss or damage from hazards of fire, explosion, burn, asphyxiation, and/or carbon monoxide poisoning. Only persons who can understand and follow the instructions should use or service this fire table. EXPLOSION - FIRE HAZARD •...
- Page 5 28" Square Fire Table - Black WARNING: For Outdoor Use Only WARNING Improper installation, adjustment, alteration, service, or maintenance can cause property damage, injury, or death. Read the installation, operation, and maintenance instructions thoroughly before installing or servicing this equipment. WARNING BURN HAZARD •...
- Page 6 Storage of an appliance indoors is permissible only if the tank is disconnected and removed from the appliance. A tank must be stored outdoors in a well-ventilated area out of the reach of children. A disconnected tank must have dust caps tightly installed and must not be stored in a building, garage, or any other enclosed area.
-
Page 7: Features
28" Square Fire Table - Black Features • 50,000 BTU creates a heat radius of 16.4 ft. (5 m) to keep everyone warm • Propane fuel source with 20 lb. (9 kg) capacity burns clean and avoids releasing harmful emissions •... -
Page 8: Parts
Parts Make sure that you have all the hardware necessary to assemble your new fire table: PART DESCRIPTION QUANTITY Table Lid Burner Assembly Table Doorframe Left Side Panel Control Panel Door Door Handle Foot Lava Rocks 1 bag Back Panel Right Side Panel Bottom Plate www.insigniaproducts.com... -
Page 9: Hardware
28" Square Fire Table - Black Hardware Note: You may not use all the included hardware. LABEL HARDWARE QTY. LABEL HARDWARE QTY. Washer M6 × 12 mm Bolt M6 × 25 mm Bolt Phillips screwdriver M4 x 6 mm Screw ST4.2 x 12 mm Bolt M5 x 8 mm Screw www.insigniaproducts.com... -
Page 10: Assembly
Assembly Fire Table Assembling your fire table......11 STEP 1: Attaching the bottom plate and feet ....11 STEP 2: Attaching the back panel . -
Page 11: Step 1: Attaching The Bottom Plate And Feet
28" Square Fire Table - Black Assembling your fire table CAUTION: We recommend that you get assistance during the assembly process to avoid strains or injury, or damage to the fire table parts. Note: Before you begin to assemble your fire table, make sure that all parts are present. Compare the parts with the package contents list and hardware contents above. - Page 12 2 Screw the four feet (I) into the bottom of the left and right side panels (E and L). Bottom of your fire table www.insigniaproducts.com...
-
Page 13: Step 2: Attaching The Back Panel
28" Square Fire Table - Black STEP 2: Attaching the back panel You need: FF Phillips screwdriver AA M6 × 12 mm bolt (4) K back panel 1 Turn the unit upright, then attach the back panel (K) to the left and right side panels (E and L) with four M6 x 12 mm bolts (AA). -
Page 14: Step 3: Installing The Door
STEP 3: Installing the door You need: G door D doorframe H Door handle CC M4 × 6 mm screw (2) EE Washer (2) AA M6 × 12 mm bolt (4) FF Phillips screwdriver 1 Attach the door handle (H) to the door by putting the M4 x 6 mm (CC) screw through the washer (EE) and through the holes in the door (G), then tightening the screws until snug. -
Page 15: Step 4: Attaching The Table To The Base Assembly
28" Square Fire Table - Black STEP 4: Attaching the table to the base assembly You need: AA M6 × 12 mm bolt (4) FF Phillips screwdriver C table 1 Place the table (C) face down on a pad or piece of cardboard (to prevent damage), then turn the base assembly over onto the table so that the holes in the base assembly align with the holes in the table. -
Page 16: Step 5: Installing The Burner Assembly
STEP 5: Installing the burner assembly You need FF Phillips screwdriver GG ST4.2 x 12 mm bolt B burner assembly 1 Turn the table assembly upright. 2 Remove the knob from the burner assembly by pulling it outward off the shaft. 3 Place the burner assembly (B) into the square cutout in the table (C) so that the four screw holes in the burner assembly align with the holes in the square cutout in the table. -
Page 17: Step 6: Installing The Control Panel
28" Square Fire Table - Black STEP 6: Installing the control panel You need: FF Phillips screwdriver DD M5× 8 mm screw (2) F control panel 1 Align the two holes in the control panel (F) with the holes in the left side panel (E), then attach the control panel with two M5 x 8 mm screws (DD). -
Page 18: Step 7: Adding The Lava Rocks
STEP 7: Adding the lava rocks You need: J Lava Rocks Note: This fire table is compatible with either lava rocks or glass stones. You can choose whichever you prefer. Lava rocks are provided with this fire table. • Add one bag of lava rocks (J) evenly to the burner tray. Do not cover the ignition parts. www.insigniaproducts.com... -
Page 19: Step 8: Installing The Propane Tank
28" Square Fire Table - Black STEP 8: Installing the propane tank To make sure that the propane tank is installed correctly, see IMPORTANT PROPANE TANK INFORMATION on page 5. WARNING: • Do not store a spare LP-gas tank under or near this appliance. •... - Page 20 4 Close the door. To disconnect the tank 1 Open the door in the front of your fire table, then loosen the wing nut that secures the tank in the tray. 2 Fully close the tank valve by turning it clockwise. 3 Turn the coupling nut counterclockwise until the regulator assembly detaches, then remove the tank.
-
Page 21: Step 9: Testing For Gas Leaks
28" Square Fire Table - Black STEP 9: Testing for gas leaks WARNING: • Perform all leak tests outdoors. • Extinguish all open flames. • NEVER leak test when smoking. • Do not use your fire table until all connections have been leak tested and do not leak. 1 Use a leak detection solution. -
Page 22: Usage
Usage Fire Table Before you begin using your fire table ... . . 23 Operation checklist......... . .23 Before turning on the gas. -
Page 23: Operation Checklist
28" Square Fire Table - Black Before you begin using your fire table WARNING: CARBON MONOXIDE HAZARD For outdoor use only. Never use inside a house, or other unventilated or enclosed areas. Your fire table consumes air (oxygen). Do not use in unventilated or enclosed areas to avoid endangering your life. -
Page 24: Lighting Your Fire Table
Using your fire table Lighting your fire table WARNING: Be careful when attempting to manually ignite your fire table. Pressing the control knob for more than 10 seconds before igniting the gas can cause a ball of flame upon ignition. your WARNING: Avoid inhaling fumes emitted from fire table’s first use. -
Page 25: Adjusting The Flame
28" Square Fire Table - Black 4 After your fire table lights, release the control knob. 5 Push in and turn the control knob to the HIGH position and leave it there for five minutes or more before turning the knob to the temperature setting you want. -
Page 26: Maintenance
Maintenance Fire Table Maintaining your fire table ......27 Cleaning your fire table........27 Inspecting your fire table . -
Page 27: Cleaning Your Fire Table
28" Square Fire Table - Black Maintaining your fire table WARNING: Do NOT touch or move your fire table for at least 45 minutes after use. Cleaning your fire table Periodically clean the exterior surfaces of your fire table with warm soapy water. Never use flammable or corrosive cleaning agents. - Page 28 PROBLEM POSSIBLE CAUSE SOLUTION Dirt or film on burner Clean the burner Carbon build-up or thick Blockage in the burner Remove any blockage and clean the burner inside black smoke and out Specifications Dimensions (WxHxD) 27.9 × 27.9 × 24.5 in. (71.1 ×...
-
Page 29: One-Year Limited Warranty
During the Warranty Period, if the original manufacture of the material or workmanship of the Product is determined to be defective by an authorized Insignia repair center or store personnel, Insignia will (at its sole option): (1) repair the Product with new or rebuilt parts; or (2) replace the Product at no charge with new or rebuilt comparable products or parts. - Page 30 1-877-467-4289 (U.S. and Canada) INSIGNIA is a trademark of Best Buy and its affiliated companies. Distributed by Best Buy Purchasing, LLC 7601 Penn Ave South, Richfield, MN 55423 U.S.A. V2 ENGLISH ©2022 Best Buy. All rights reserved. 22-0216...
Need help?
Do you have a question about the NS-PFT28BK3 and is the answer not in the manual?
Questions and answers