Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Aqua Perfecta Pura
- Page 1 Installation Manua Pura AquaPerfecta.com 0800 007 3737...
-
Page 2: Table Of Contents
Preface Congratulations on purchasing the Pura water purification system from Aqua Perfecta. With patented technology, remarkable quality and unique design we are sure you will be happy sharing our ethos of demanding uncompromising quality in your drinking water. Each item is subject to strict quality and function inspection before delivery, thus there may be some water remaining in the system. -
Page 3: Unpacking
① ⑦ ⑧ ⑨ ○ ⑩ ○ ○ Pura Housing Pressurised Tank Tap Nut ⅜" Union Connector RO Membrane Wrench Combo Cartridge Filter PE Tube x White x ⅜" x 1.5 m 10. PE Tube x Yellow x ¼" x 1.5 m 11. -
Page 4: Required Tools
Open the lid Open the lid of the Pura housing. Remove the combo cartridge filter from the Pura. The combo cartridge filter has been loaded into the Pura for transportation. Two small black There are two small black rubber seals rubber seals on one side of the membrane. -
Page 5: Combo Cartridge Filter Usage
5 Combo Cartridge Filter Usage Remove the film wrapping from the filter before use. And then put the combo cartridge filter back into the Pura housing. Make sure that the O-ring on the edge of the lip is properly seated and then evenly close the lid by hand. And then use the wrench to tighten the lid gently. -
Page 6: Tap Installation
7 Tap Installation Choose the appropriate installation location before starting. The tap should be located where it is easy to use. To install the tap on the kitchen counter, you need to drill a 12mm hole in the kitchen counter or the corner of the stainless steel sink. -
Page 7: Feed Water Connecting
8 Connecting The Water Inlet Integrated The integrated adaptor comes with mains water supply and Adaptor adaptor connections. Angle Valve Turn off the mains water by closing the angle valve under the sink. Unscrew the cold water pipe and then connect the integrated Cold water pipe adaptor to the angle valve. -
Page 8: Ports Connecting
10 Connecting The Ports On the black base of the Pura, you will see three ports. Connecting steps are as follows: Inlet Port (left side) This is the inlet port of the Pura. Inlet Port Connect it to the integrated adapter with ¼” blue tube. -
Page 9: First Commissioning
The tubing must be laid without twists or bending. Turn on the water supply and check all connections for leaks. Let the tank fill and empty 3 times before drinking the water. After that, enjoy your Pura water! Manual Timer Set the next filter change time (day/month). -
Page 10: Troubleshooting
Ball valve of tank closed Open the ball valve The cartridge filter installed in Take it out and put it back again Pura housing improperly properly The membrane is in wrong Take it out and put it back in direction... -
Page 11: Required Raw Water Quality And Conditions
Detection/Error Problem Causes Solutions The tank is located near heat Install the tank in other location source area Tubes connected to wrong ports Tubelines inspection Ports / Tubes are leaking Ports and tubes Tubes bent or not fully Tubelines inspection connected improperly connected Pull out the tubes and plug into... - Page 12 AquaPerfecta.com 0800 007 3737...
Need help?
Do you have a question about the Pura and is the answer not in the manual?
Questions and answers