Maintenance Tips + Warranty - Prince 7000 Owner's Manual

1.
1. Cleaning the machine
a. String clamps, string clamp rails, and speed jaws must be cleaned regularly with alcohol to
minimize string slippage.
b. If the string clamp base slips after cleaning rails turn the base adjustment screw 1/8 turn
clockwise using the 3mm L-shaped allen wrench.
c. Do not over tighten adjustment screw or damage may occur
2. Clamp Maintenance
a. To improve the life of your clamps, apply a small amount of grease to contact points
(picture #2). Open and close the clamp several times to distribute the grease. Wipe off
any excess grease before stringing.
b. Periodically check the 2 points to insure they remain greased. Apply grease to clamp
post, then wipe gently with a dry cloth leaving a thin film of grease on the surface. The
lubricated surface ensures a smooth operation and provides rust protection.
3. To calibrate the machine, remove the knob on the right side of the Tension Head / Display. Use
screw driver out of the tool kit to adjust the correct pulling tension. Additionally needed is a pulling
scale that is not delivered with the machine.
AS WITH ANY MACHINE WITH MOVING PARTS AND ELECTRONIC POWER, SIGNIFICANT INJURY CAN
OCCUR IF PROPER CARE IS NOT EXCERCISED WHEN USING THE PRINCE 7000 STRINGING MACHINE.
THIS MACHINE IS ONLY TO BE UTILIZED IN STRICT COMPLIANCE WITH THE INSTRUCTIONS SET FORTH
IN THIS MANUAL.
Maintenance Tips
2.
9
3.