Products to the common carrier of Pace Technologies choice, or the carrier specified in writing by Customer, for shipment to Customer. An y claims for breakage, loss, delay, or damage shall be made to the carrier by the Customer and Pace Technologies will render customer reasonable assistance in prosecuting such claims.
Page 5
All Returns are subject to a restocking charge equal to 15% (fifteen percent) of the Invoice, unless the Goods are proved to be non-conformed by PACE Technologies. fees and other costs of suit including costs and attorneys’ fees incurred on appeal or in collection of any judgment.
• The PICO-200 has a large cutting area and is capable of sectioning long parts. The PICO-200 features a wheel feeding mechanism. The ability to move the blade into the sample allows control of the cutting pressure and feed rates.
Page 8
Vertical vices are utilized to clamp down on surfaces of samples, including irregular shaped samples. • The PICO-200 is a variable speed diamond saw. The ability to adjust the rpm is essential to properly tune a procedure and to ensuring the quality of the cut...
100 to 3000 rpm. Adjustments are very visible due to the PICO-200’s large digital LCD readout display. • The PICO-200 utilizes a magnetic stop sensor for an added layer of safety while the machine is powered on. If the hood is opened the machine will cut power to the motor and stop the blade from rotating.
Page 10
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1-520-882-6598 Fax +1-520-882-6599 email: pace@metallographic.com Web: https://www.metallographic.com 2.3 Installation • The PICO-200 should be placed on a stable flat surface with access to drain and electrical connections. • After drain and electrical connection are establish the system is ready for operation by activating the main power switch.
Careful attention to this instruction manual and the recommended safety guidelines is essential for the safe operation of the PICO-200. Proper operator training is required for operation of the PICO-200. Any unauthorized mechanical or electrical modifications made to the PICO-200, as well as improper operation, voids all warranty claims.
Page 12
Web: https://www.metallographic.com 3.4 Safety Test Important: The following safety check of the magnetic safety cut-off switch is required to verify that he PICO-200 is functioning properly and is ready to use. Test: 1). Activate main power switch to turn on machine.
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1-520-882-6598 Fax +1-520-882-6599 email: pace@metallographic.com Web: https://www.metallographic.com 4.0 Start-up and Operation 4.1 General • The PICO-200 is a highspeed table saw. 4.2 Control Panel Cutting Wheel On: Starts the cutting wheel.
Page 16
4.5 Cutting (Step-by-Step Procedure) 1. Ensure sample is secured properly to the table’s surface (see reference section Securing a Sample above). 2. Close the PICO-200 acrylic hood. 3. Power on the PICO-200. 4. Set the desired rpm using the speed adjustment knob.
Page 18
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1-520-882-6598 Fax +1-520-882-6599 email: pace@metallographic.com Web: https://www.metallographic.com 5.3 Service Panel • The PICO-200 is equipped with a removable side panel for service access. Please read this instruction manual carefully and follow all installation, operating and safety guidelines.